|
|
Asymmetric Roll Force Calculation With Additional Tilt for Drive Side and Operator Side of Cold Strip Mill |
LIU Bao-quan1,2,ZHANG Hong1,WANG Zi-dong1,WANG Jun-sheng2,ZHANG Yan2 |
1. School of Materials Science and Engineering, University of Science and Technology Beijing, Beijing 100083, China 2. Angang Steel Company Limited, Anshan 114021, Liaoning, China |
|
|
Abstract The single edge wave and strip break caused by excessive tilting adjustment were analyzed. Influence function method was adopted to model the roll deformation. Adding different tilt, roll force of drive side, roll force of operator side, transverse distribution of contact pressure between rolls, transverse distribution of roll force, transverse distribution of strip thickness at exit side and transverse distribution of tension at exit side were calculated by using iterative method. The theoretical calculation and the actual measurement results show that the difference between the bilateral increases almost linearly with tilt adjustment value. The break strip accidents are effectively averted by dynamic limiting to tilt setting value with the measured differential roll force, according to the proportional relationship between the differential roll force and the tilt.
|
Received: 27 October 2010
Published: 01 November 2011
|
|
|
|
[1] |
WANG Dong-cheng,,WU Yan-lin,LIU Hong-min,. High-efficiency calculation method for roll stack elastic deformation of four-high mill[J]. Iron and Steel, 2015, 50(11): 69-74. |
[2] |
CHEN Li-zhang,CHANG Chong-min,WANG Chun-li. Strip Properties and Corrosion Mechanism Corroded by Aluminum-Zinc-Silicon Hot-Dip Solution[J]. Chinese Journal of Iron and Steel, 2014, 26(10): 26-29. |
[3] |
LIANG Xun-guo. Preset Model of Bending Force for Six-High Tandem Cold Rolling Mill[J]. Iron and Steel, 2014, 49(10): 41-43. |
[4] |
tong qiang Xianghua LIU. Theory Analysis of Roll Crossing in View of 6H3C Single Cold Rolling Mill[J]. Chinese Journal of Iron and Steel, 2010, 22(04): 20-20. |
[5] |
ZHANG Dianhua;ZHAO Xuliang;XU Jianzhong;CHEN Jilin;LU Zhenghong;AN Wenjun. Roll Contour Optimization Design of 1 250 mm Hot Strip Mill[J]. Chinese Journal of Iron and Steel, 2009, 21(1): 26-0. |
[6] |
LI Haijun;ZHAO Xuliang;ZHANG Dianhua;WANG Guodong;CHEN Feng. Influence of Workpiece Width on Hot Strip Mill Stretch[J]. Iron and Steel, 2008, 43(12): 49-0. |
|
|
|
|