|
|
Effects of temperature and composition of molten iron on dissolution behavior of carbon brick |
DENG Yong1,2,ZHANG Jian-liang1,2,JIAO Ke-xin1,2 |
(1. School of Metallurgical and Ecological Engineering, University of Science and Technology Beijing, Beijing 100083, China 2. State Key Laboratory of Advanced Metallurgy, University of Science and Technology Beijing,Beijing 100083, China) |
|
|
Abstract In order to explore the dissolution behavior of carbon brick in molten iron,molten iron with different element contents was disposed based on actual molten iron composition in hearth. Carbon bricks made of cylindrical specimens were immersed into molten iron to carry out the experiments with rotating finger stick method. The results show that the dissolution reaction is the main reaction of carbon brick erosion,SEM found the hole diameter of carbon brick increase at the interface after the experiment. The quantitative relationship between temperature,element content and erosion was obtained through the experimental results,the characteristic parameters were selected to compare the influence degree of element content on the erosion. The kinetics model of carbon dissolution reaction was established,the effect of element content on the reaction rate constant was analyzed,the activation energy was calculated to be 46.38 kJ/mol.
|
Received: 15 November 2017
Published: 11 May 2018
|
|
|
|
|
[1] |
LIU Z J, ZHANG J L, YANG T J, et al.Recent Progress on Long Service Life Design of Chinese Blast Furnace Hearth[J].ISIJ Int, 2012, 52(10):1713-1723
|
[1] |
LIU Z J, ZHANG J L, YANG T J, et al.Recent Progress on Long Service Life Design of Chinese Blast Furnace Hearth[J].ISIJ Int, 2012, 52(10):1713-1723
|
[2] |
DENG Y, ZHANG J L, JIAO K X.Residual thickness of carbon brick calculation model and systematic analysis of heat transfer[J].Metall. Res. Technol., 2017, 114(210):1-9
|
[2] |
DENG Y, ZHANG J L, JIAO K X.Residual thickness of carbon brick calculation model and systematic analysis of heat transfer[J].Metall. Res. Technol., 2017, 114(210):1-9
|
[3] |
JIAO K X, ZHANG J L, LIU Z J, et al.Analysis of Blast Furnace Hearth Sidewall Erosion and Protective Layer Formation[J].ISIJ Int, 2016, 56(11):1956-1963
|
[3] |
JIAO K X, ZHANG J L, LIU Z J, et al.Analysis of Blast Furnace Hearth Sidewall Erosion and Protective Layer Formation[J].ISIJ Int, 2016, 56(11):1956-1963
|
[4] |
ZHENG K C, WEN Z, LIU X L, et al.Research Status and Development Trend of Numerical Simulation on Blast Furnace Lining Erosion[J].ISIJ Int, 2009, 49(9):1277-1282
|
[4] |
ZHENG K C, WEN Z, LIU X L, et al.Research Status and Development Trend of Numerical Simulation on Blast Furnace Lining Erosion[J].ISIJ Int, 2009, 49(9):1277-1282
|
[5] |
ZHANG F M.Design and Operation Control for Long Campaign Life of Blast Furnaces[J].Journal of iron and steel research, international., 2013, 20(9):53-60
|
[5] |
ZHANG F M.Design and Operation Control for Long Campaign Life of Blast Furnaces[J].Journal of iron and steel research, international., 2013, 20(9):53-60
|
[6] |
ZHANG S R, YIN H.The 5th International Congress on the Science and Technology of Ironmaking[J].The 5th International Congress on the Science and Technology of Ironmaking, 2009, 16(5):1-13
|
[6] |
ZHANG S R, YIN H.The 5th International Congress on the Science and Technology of Ironmaking[J].The 5th International Congress on the Science and Technology of Ironmaking, 2009, 16(5):1-13
|
[7] |
Cham S T, Sakurovs R, Sun H, et al.Influence of Temperature on Carbon Dissolution of Cokes in Molten Iron[J].ISIJ Int, 2006, 46(5):652-659
|
[7] |
Cham S T, Sakurovs R, Sun H, et al.Influence of Temperature on Carbon Dissolution of Cokes in Molten Iron[J].ISIJ Int, 2006, 46(5):652-659
|
[8] |
Shigeno Y, Tokuda M, Ohtani M.The Dissolution Rate of Graphite into Fe–C Melt Containing Sulphur or Phosphorus[J].Materials Transactions Jim, 1985, 26(1):33-43
|
[8] |
Shigeno Y, Tokuda M, Ohtani M.The Dissolution Rate of Graphite into Fe–C Melt Containing Sulphur or Phosphorus[J].Materials Transactions Jim, 1985, 26(1):33-43
|
[9] |
Mourao M B, Krishnamurthy G G, Elliot J F.Experimental investigation of dissolution rates of carbonaceous materials in liquid iron-carbon melts[J].Metallurgical Transactions B, 1993, 24(4):629-637
|
[9] |
Mourao M B, Krishnamurthy G G, Elliot J F.Experimental investigation of dissolution rates of carbonaceous materials in liquid iron-carbon melts[J].Metallurgical Transactions B, 1993, 24(4):629-637
|
[10] |
Kayama N, Ishikawa O.91 Consideration of Some Phenomena at Electro-Slag Remelting[J].91 Consideration of Some Phenomena at Electro-Slag Remelting, 1965, 51:1946-1948
|
[10] |
Kayama N, Ishikawa O.91 Consideration of Some Phenomena at Electro-Slag Remelting[J].91 Consideration of Some Phenomena at Electro-Slag Remelting, 1965, 51:1946-1948
|
[11] |
Wright J K, Baldock B R.Dissolution kinetics of particulate graphite injected into ironcarbon melts[J].Metallurgical Transactions B, 1988, 19(3):375-382
|
[11] |
Wright J K, Baldock B R.Dissolution kinetics of particulate graphite injected into ironcarbon melts[J].Metallurgical Transactions B, 1988, 19(3):375-382
|
[12] |
Kalvelage L, Markert J, Poetschke J.Measuring the Dissolution of Graphite in Liquid Iron by Following the Buoyancy[J].Arch. Eisenhuttnwes, 1979, 50:53-60
|
[12] |
Kalvelage L, Markert J, Poetschke J.Measuring the Dissolution of Graphite in Liquid Iron by Following the Buoyancy[J].Arch. Eisenhuttnwes, 1979, 50:53-60
|
[13] |
Orsten S, Oeters F.Degassing of coal particles injected into iron melts[J].Steel Research International, 1989, 60(3):145-150
|
[13] |
Orsten S, Oeters F.Degassing of coal particles injected into iron melts[J].Steel Research International, 1989, 60(3):145-150
|
[14] |
Hisatsuna Ch, Shinodd T, and Sae Sh.Imonology, 1965, 37(4):27-34.[J].Imonology, 1965, 37(4):27-34
|
[14] |
Hisatsuna Ch, Shinodd T, and Sae Sh.Imonology, 1965, 37(4):27-34.[J].Imonology, 1965, 37(4):27-34
|
[15] |
Dahlke V O, Knacke O.Die Aufl?sung von Kohlenstoff in flüssigem Eisen[J].Steel Research International, 1955, 26(7):373-378
|
[15] |
Dahlke V O, Knacke O.Die Aufl?sung von Kohlenstoff in flüssigem Eisen[J].Steel Research International, 1955, 26(7):373-378
|
[16] |
Shurygin P M, Kryk V I.Izv[J].Vysshikh Uchebn. Zavedenii Chernaya Met., 6 Dec, 1963, 35(7):14-19
|
[16] |
Shurygin P M, Kryk V I.Izv[J].Vysshikh Uchebn. Zavedenii Chernaya Met., 6 Dec, 1963, 35(7):14-19
|
[17] |
郭汉杰.冶金物理化学教程[M].北京:冶金工业出版社,2006.
|
[17] |
郭汉杰.冶金物理化学教程[M].北京:冶金工业出版社,2006.
|
[18] |
GUO H J.Physical chemistry of metallurgy [M].Beijing: Metallurgical industry press, 2006.
|
[18] |
GUO H J.Physical chemistry of metallurgy [M].Beijing: Metallurgical industry press, 2006.
|
[19] |
Jang D, Kin Y, Shin M, et al.Kinetics of Carbon Dissolution of Coke in Molten Iron[J].Metallurgical and Materials Transactions B, 2012, 43(6):1308-1314
|
[19] |
Jang D, Kin Y, Shin M, et al.Kinetics of Carbon Dissolution of Coke in Molten Iron[J].Metallurgical and Materials Transactions B, 2012, 43(6):1308-1314
|
[1] |
ZHU De-qing1,TIAN Hong-yu1,PAN Jian1,LIAO Hui2,GUO Zheng-qi1,XUE Yu-xiao1. Comprehensive utilization status and progress of low-grade laterite nickel ore[J]. JOURNAL OF IRON AND STEEL RESEARCH , 2020, 32(5): 351-362. |
[2] |
WANG Kun1,LIU Xiao-jie1,LIU Er-hao2,LI Hong-yang1,LIU Song1,LV Qing1. Core temperature prediction model based on AdaBoost algorithm[J]. JOURNAL OF IRON AND STEEL RESEARCH , 2020, 32(5): 363-369. |
[3] |
RONG Tao, TANG Hui-qing, FAN Kai, SUN Yan-jun. Applying high-carbon metallic briquette in blast furnace for coke saving[J]. Iron and Steel, 2020, 55(5): 10-19. |
[4] |
ZHANG Jian-liang, SUN Min-min, LI Ke-jiang, LI Hong-tao. Present situation and prospect of dissolution behavior of metallurgical coke in blast furnace hot metal[J]. Iron and Steel, 2020, 55(4): 1-11. |
[5] |
WANG Jin-liang, DAI Xi, ZHANG Wei, GONG Shu-shan, ZHOU Guo-zhi, ZHANG Wen-hai. Advances of non-blast furnace flash iron-making researches[J]. Iron and Steel, 2020, 55(4): 100-105. |
[6] |
ZHANG Xiao-hua, ZHAO Kai, BAI Geng-chen, ZHANG Yu-zhu, GAO Jian-jun, ZHANG Ying-yi. Thermal analysis of rotary kiln-oxygen combustion melting furnace under multi-constraint conditions[J]. Iron and Steel, 2020, 55(3): 9-15. |
|
|
|
|