1. Institute for Special Steels, Central Iron and Steel Research Institute, Beijing 100081, China 2. Technical Center of Fushun Special Steel Co., Ltd., Dongbei Special Steel Group Co., Ltd., Fushun 113001, Liaoning,China 3. Faculty of Materials Science and Engineering, Kunming University of Science and Technology,Kunming 650093, Yunnan, China
1. Institute for Special Steels, Central Iron and Steel Research Institute, Beijing 100081, China 2. Technical Center of Fushun Special Steel Co., Ltd., Dongbei Special Steel Group Co., Ltd., Fushun 113001, Liaoning,China 3. Faculty of Materials Science and Engineering, Kunming University of Science and Technology,Kunming 650093, Yunnan, China
ժҪ The hot deformation behavior of F6NM stainless steel was investigated by hot compression test in a Gleeble-1500D thermal-mechanical simulator. The flow strain-stress curves were obtained and the corresponding metallographic observation of this steel under different deformation conditions was also carried out. This steel exhibited dynamic recrystallization (DRX) in the temperature range of 1273-1473 K and the strain rate range of 0.01-0.1 s-1. The activation energy for hot deformation was determined to be 457.91 kJ/mol, and the hot deformation equations were also established. The flow instability zone was determined and could be divided into two regions. The first one was located in the temperature range of 1173-1348 K and the strain rate range of 0.056-10 s-1, while the second one is in the temperature range of 1398-1448 K and the strain rate range of 1.25-10 s-1. In the end, the optimum conditions for hot working were provided.
Abstract��The hot deformation behavior of F6NM stainless steel was investigated by hot compression test in a Gleeble-1500D thermal-mechanical simulator. The flow strain-stress curves were obtained and the corresponding metallographic observation of this steel under different deformation conditions was also carried out. This steel exhibited dynamic recrystallization (DRX) in the temperature range of 1273-1473 K and the strain rate range of 0.01-0.1 s-1. The activation energy for hot deformation was determined to be 457.91 kJ/mol, and the hot deformation equations were also established. The flow instability zone was determined and could be divided into two regions. The first one was located in the temperature range of 1173-1348 K and the strain rate range of 0.056-10 s-1, while the second one is in the temperature range of 1398-1448 K and the strain rate range of 1.25-10 s-1. In the end, the optimum conditions for hot working were provided.
2014, Vol. 21 
