1. National Engineering Research Center for Equipment and Technology of Cold Strip Rolling, Yanshan University,Qinhuangdao 066004, Hebei, China 2. College of Metallurgy and Energy, North China University of Science and Technology, Tangshan 063009, Hebei, China 3. Equipment Manufacturing College, Hebei University of Engineering, Handan 056038, Hebei, China
Constitutive Model of Warm Deformation Behavior of Medium Carbon Steel
1. National Engineering Research Center for Equipment and Technology of Cold Strip Rolling, Yanshan University,Qinhuangdao 066004, Hebei, China 2. College of Metallurgy and Energy, North China University of Science and Technology, Tangshan 063009, Hebei, China 3. Equipment Manufacturing College, Hebei University of Engineering, Handan 056038, Hebei, China
ժҪ The compressive behaviors of medium carbon steel specimens were investigated over a wide range of temperatures and strain rates using a Gleeble��3500 thermo��simulation machine. The results show that the flow stress increased with strain at first, and then gradually decreased after reaching a peak value. The flow stress softening rate at a high strain rate was larger than that at a low strain rate. The effects of deformation heating and friction on flow stress were analyzed. A new friction correction method, wherein the effect of strain on frictional coefficient was considered, was established here. The stresses revised by the new method deviated from the measured stresses with increasing strain. Meanwhile, the apparent frictional coefficient variation law with strain was obtained. The frictional coefficient increased as the strain increased and then slightly decreased after maintaining a constant value. The stress was corrected by considering deformation heating. The accuracy of the temperature correction method was verified using a special experiment. The results of the verification experiment show that the temperature correction method exhibited a good accuracy in calculating the variation of stress caused by deformation heating. A constitutive model considering strain was proposed here to describe the deformation behaviors. Compared with experimental data, the modified constitutive model exhibited a good accuracy as to constitutive correlation.
Abstract��The compressive behaviors of medium carbon steel specimens were investigated over a wide range of temperatures and strain rates using a Gleeble��3500 thermo��simulation machine. The results show that the flow stress increased with strain at first, and then gradually decreased after reaching a peak value. The flow stress softening rate at a high strain rate was larger than that at a low strain rate. The effects of deformation heating and friction on flow stress were analyzed. A new friction correction method, wherein the effect of strain on frictional coefficient was considered, was established here. The stresses revised by the new method deviated from the measured stresses with increasing strain. Meanwhile, the apparent frictional coefficient variation law with strain was obtained. The frictional coefficient increased as the strain increased and then slightly decreased after maintaining a constant value. The stress was corrected by considering deformation heating. The accuracy of the temperature correction method was verified using a special experiment. The results of the verification experiment show that the temperature correction method exhibited a good accuracy in calculating the variation of stress caused by deformation heating. A constitutive model considering strain was proposed here to describe the deformation behaviors. Compared with experimental data, the modified constitutive model exhibited a good accuracy as to constitutive correlation.
Hong��bin LI,,Yun��li FENG,Tao YAN,En��lin YU. Constitutive Model of Warm Deformation Behavior of Medium Carbon Steel[J]. �й������ڿ���, 2016, 23(9): 940-948.
Hong��bin LI,,Yun��li FENG,Tao YAN,En��lin YU. Constitutive Model of Warm Deformation Behavior of Medium Carbon Steel. Chinese Journal of Iron and Steel, 2016, 23(9): 940-948.