|
|
|
| Finite Element Simulation of Cold-Rolling Process of Shaped Steel Tube for Driving Shaft |
| SHUAI Mei-rong, LIU Shao-bo, GAO Cong-min, et al |
|
|
|
|
Abstract Based on the deformation characteristics of Y-type mill, this paper proposes a finite element model for dynamically simulating the formation process of shaped steel tube for driving shaft. The distributions of stress and strain were obtained from the simulation. The outer diameter and transverse wall thickness were also analyzed quantitatively. Experiment was done on Y-type mill. A comparison between simulation results and experiment results shows that the simulating results of shaped steel tube are in good agreement with the on-site data. The model could provide the basis for theoretical research and engineering applications of shaped steel tube rolling process.
|
|
Received: 12 August 2009
|
|
Corresponding Authors:
SHUAI Mei-Rong
|
|
|
|
| [1] |
Fu-yong Su*,Zhi Wen. Hydraulic experiment on mushroom head in bottom-blown smelting furnace[J]. Chinese Journal of Iron and Steel, 2017, 24(5): 490-494. |
| [2] |
Da-shan Sui,*,Hai-ming Zhang,Hong-yang Zhu,Zhe Zhu,Zhen-shan Cui. Effects of process parameters on fragment and refinement of millimeter-grade coarse grains for 316LN steel during hot cogging[J]. Chinese Journal of Iron and Steel, 2017, 24(5): 529-535. |
| [3] |
Nan-nan Zhang,*,Dan-yang Lin,Ya-li Li,Yue Zhang,Marie-pierre Planche,Han-lin Liao, Christian Coddet,Fu-yu Dong. In-flight particle characterization and coating formation under low pressure plasma spray condition[J]. Chinese Journal of Iron and Steel, 2017, 24(3): 306-312. |
| [4] |
Zheng CHEN,,Qi��jie ZHAI,Jie��yu ZHANG,Hong��gang ZHONG. Effects of Thermal Gradients and Rotational Flows on Grain Growth in 22 t Steel Ingots[J]. Chinese Journal of Iron and Steel, 2016, 23(9): 973-980. |
| [5] |
Zheng-wei GU,,Meng-meng L��,,Xin LI,,Hong XU,. Stretch Bending of Z-section Stainless Steel Profile[J]. Chinese Journal of Iron and Steel, 2016, 23(6): 525-530. |
| [6] |
Hui ZHANG,Peng HU,,Ming-lin WANG. Mechanism and Improvement of Straight Edge Seam Defect on Hot-rolled Plate Surfaces through Use of Chamfered Slabs[J]. Chinese Journal of Iron and Steel, 2016, 23(6): 539-546. |
|
|
|
|
2010, Vol. 17 
