|
|
|
| Effect of Thermomechanical Control Processing on Microstructure and Mechanical Properties of Fe-0.2C-1.44Si-1.32Mn Hot-rolled TRIP Steel |
| ZHANG Zi-Cheng , ZHU Fu-xian LI Yan-mei |
|
|
|
|
Abstract The effect of thermomechanical control processing (TMCP) on microstructure and mechanical properties of Fe-0.2C-1.44Si-1.32Mn hot-rolled TRIP steel was investigated by experiment. Strain-induced transformation and transformation-induced plasticity behavior of retained austenite was discussed. The results show that using multi-pass deformation, reduction per pass of more than critical deformation in austenite recrystallization region, total reduction of more than 58 pct in non-recrystallization region and in high temperature section of two-phase region can result in austenite being refined before �� �� �� transformation. It is beneficial to get refined ferrite grain in final microstructure. To obtain fine and uniform microstructure and excellent strength-ductility balance, a three-step cooling process (Laminar Cooling��Air Cooling��Ultra-Fast Cooling) after hot rolling was conducted. The ultimate tensile strength and elongation of the testing steel can reach 663 MPa and 41 pct respectively.
|
|
Received: 29 April 2009
|
|
Corresponding Authors:
Zi-Cheng ZHANG
|
|
|
|
| [1] |
Xiao-li Zhao,,Yong-jian Zhang,Cheng-wei Shao,Wei-jun Hui,Han Dong. Thermal stability of retained austenite and mechanical properties of medium-Mn steel during tempering treatment[J]. Chinese Journal of Iron and Steel, 2017, 24(8): 830-837. |
| [2] |
Hui Guo,Peng Zhou,*,Ai-min Zhao,,Chao Zhi,Ran Ding,Jia-xing Wang. Effects of Mn and Cr contents on microstructures and mechanical properties of low temperature bainitic steel[J]. Chinese Journal of Iron and Steel, 2017, 24(3): 290-295. |
| [3] |
Ji-bo Peng,,Hu Jiang,,Gong-ting Zhang,Li-ben Chen,,Na-qiong Zhu,,Yan-lin He,,*, Xiao-gang Lu,,Lin Li,. In-situ analysis of retained austenite transformation in high-performance micro-alloyed TRIP steel[J]. Chinese Journal of Iron and Steel, 2017, 24(3): 313-320. |
| [4] |
Chen-chong Wang,Chi Zhang*,Zhi-gang Yang. Effects of Ni on austenite stability and fracture toughness in high Co-Ni secondary hardening steel[J]. Chinese Journal of Iron and Steel, 2017, 24(2): 177-183. |
| [5] |
Shi-meng ZHOU,,Xing-wang CHENG,,You-jing ZHANG,,Meng WANG,,Wen JIANG,,Hong-nian CAI,. Factors Affecting the Mechanical Properties of Ultra-high-strength Bainitic Steel Containing W and 0.33 mass% C[J]. Chinese Journal of Iron and Steel, 2016, 23(3): 289-296. |
| [6] |
Ming MA,Hua DING,Zheng-you TANG,Jing-wei ZHAO,Zhou-hua JIANG,Guang-wei FAN. Effects of Temperature and Strain Rate on Flow Behavior and Microstructural Evolution of Super Duplex Stainless Steel under Hot Deformation[J]. Chinese Journal of Iron and Steel, 2016, 23(3): 244-252. |
|
|
|
|
2010, Vol. 17 
