|
|
|
| Effects of Twin-Dislocation and Twin-Twin Interactions on the Strain Hardening Behavior of TWIP Steels |
WANG Shu��han, LIU Zhen��yu, WANG Guo��dong, et al
|
|
|
|
|
Abstract In the present paper, tensile tests of Fe-30Mn-5Si -2Al steel were carried out for different strains of 0.05, 0.14, 0.26, and up to the strain-to-failure in order to observe the evolution of microstructure during deformation and investigate the strain hardening behavior. Three-stage strain hardening behavior was observed in this steel during tensile test. In stage I, planar dislocation structure was observed by TEM to be the main deformation mechanism, and low strain hardening rate exponent was exhibited. Primary deformation twinning occurred in stage II, and the strain hardening rate exponent increased due to the blockage of dislocations�� motion by twin boundaries. In stage III, the strain hardening rate exponent had increased to be higher than 0.5. The obstacle effect of twin boundaries and twin-twin interaction had been observed by TEM, and the interactions between primary and secondary twins were found to cause the additional hardening in addition to the obstacle effect on dislocations�� motion, which led to the twinning induced plasticity effect in the later stage of deformation.
|
|
Received: 29 October 2009
|
|
Corresponding Authors:
Shu Han Wang
|
|
|
|
| [1] |
Yang Yun,Qing-wu Cai,,Bao-sheng Xie,*,Shuang Li. Effect of tempering temperature on strain hardening exponent and flow stress curve of 1000 MPa grade steel for construction machinery[J]. Chinese Journal of Iron and Steel, 2017, 24(9): 950-956. |
| [2] |
Li-li MA,Ying-hui WEI,,Li-feng HOU,Chun-li GUO. Evaluation on Fatigue Performance and Fracture Mechanism of Laser Welded TWIP Steel Joint Based on Evolution of Microstructure and Micromechanical Properties[J]. Chinese Journal of Iron and Steel, 2016, 23(7): 677-684. |
| [3] |
Bao- sheng XIE,Qing- wu CAI,Wei YU,Shi- xin XU,Ban WANG. A Flow Stress Model for High Strength Steels with Low Carbon Bainite Structure[J]. Chinese Journal of Iron and Steel, 2016, 23(4): 372-379. |
| [4] |
Kang-wei LI , Chang-ling ZHUANG , Jian-hua LIU, Shao-bo SHEN , Yi-long JI, Zhi-biao HAN. Plasticity Steel for Automobiles[J]. Chinese Journal of Iron and Steel, 2015, 22(Supplement 1): 75-79. |
| [5] |
Suleyman KILIC,Fahrettin OZTURK,Tayfun SIGIRTMAC,Gokhan TEKIN. Effects of Pre-strain and Temperature on Bake Hardening of TWIP900CR Steel[J]. Chinese Journal of Iron and Steel, 2015, 22(4): 361-365. |
| [6] |
Zhi-ping XIONG,,Xue-ping REN,Jian SHU,,Zhe-lei WANG,Wei-ping BAO,,Shu-xia LI. Effect of Temperature on Microstructure and Deformation Mechanism of Fe-30Mn-3Si-4Al TWIP Steel at Strain Rate of 700 s-1[J]. Chinese Journal of Iron and Steel, 2015, 22(2): 179-184. |
|
|
|
|
2010, Vol. 17 
