|
|
High Temperature Deformation Behavior of Fe-9Ni-C Alloy |
ZHANG Kun,WU Hui-bin,TANG Di |
Engineering Research Institute, University of Science and Technology Beijing, Beijing 100083, China |
|
|
Abstract The high temperature deformation behavior of the 9Ni steel has been studied by the Gleeble-3500 tester. The relationship between deformation resistance and deformation degree, deformation temperature and deformation rate was revealed. The results show that when the deformation degree is less than 0��2, the deformation resistance increases by about 70 to 200 MPa, while the deformation degree varied between 0��2 and 0��4, the deformation resistance increases by about 30-40 MPa, when the deformation degree is larger than 0��4, the deformation resistance increases slowly, some become stable gradually. The influence of deformation temperature on deformation resistance is larger, and deformation resistance at higher temperature is about 160 MPa smaller than at lower temperature. Higher deformation rate leads to larger deformation resistance. The deformation resistance increases about 70 to 110 MPa with the increase of the deformation rate. A new and highly accurate mathematical model of the steel was established to describe the deformation behavior during rolling.
|
Received: 06 May 2011
Published: 29 May 2012
|
Corresponding Authors:
Kun ZHANG
E-mail: siekom219@126.com
|
|
|
|
[1] |
DONG Ze-shang��XUE Qing-guo��ZUO Hai-bin��SHE Xue-feng��WANG Guang��WANG Jing-song. Mathematical model analysis on coke oven gas injection into oxygen blast furnace[J]. Chinese Journal of Iron and Steel, 2017, 52(4): 18-24. |
[2] |
HU Chang-qing��YAN Long-ge��ZHAO Kai. Model construction and control method for power generation system of parallel sintering waste heat boiler[J]. Chinese Journal of Iron and Steel, 2017, 52(3): 88-92. |
[3] |
GUO Long��ZHANG Xing-zhong��YUE Li-tao��FENG Chang-xi. Improvement on burden distribution of bell-less top in blast furnace[J]. Chinese Journal of Iron and Steel, 2017, 52(3): 15-20. |
[4] |
ZHAO Dan-ting����LIU Ai-qiang��QIU Sheng-tao��LAI Chao-bin. Physical-mathematical simulation and application of flow field of molten steel in tundish with filter[J]. Chinese Journal of Iron and Steel, 2017, 52(1): 27-31. |
[5] |
MA Cai-sheng��REN Ting-zhi. Analysis on wear of chute in blast furnace with bell-less top based on friction work principle[J]. Chinese Journal of Iron and Steel, 2017, 52(1): 19-26. |
[6] |
QIAN Hong-zhi,,DU Chen-wei,HU Pi-jun,,ZHANG Jia-quan,LIAO Hui,. Free thermal shrinkage behavior during the solidification process in slab casters[J]. Chinese Journal of Iron and Steel, 2016, 28(8): 27-32. |
|
|
|
|