|
|
Friction Estimation and Roll Force Prediction during Hot Strip Rolling |
Wei-gang LI1,Chao LIU1,Ning FENG1,Xi CHEN1,Xiang-hua LIU2 |
1. College of Information Science and Engineering, Wuhan University of Science and Technology, Wuhan 430081, Hubei,China 2. Research Institute of Science and Technology, Northeastern University, Shenyang 110819, Liaoning, China |
|
|
Abstract A mathematical model of friction coefficient was proposed for the roll force calculation of hot-rolled strips. The online numerical solving method of the roll force calculation formula based on the proposed friction model was developed and illustrated by the practical calculation case. Then, the friction coefficient during hot strip rolling was estimated from the measured roll force by force model inversion. And then, the expression of friction model was proposed by analyzing the calculation process of stress state coefficient, and the model parameters were determined by the shared parameter multi-model nonlinear optimization method. Finally, the industrial experiments demonstrated the feasibility and effectiveness of the related models. The accuracy of the new roll force model based on the built friction model was much higher than that of the traditional Sims model, and it could be applied in the online hot rolling process control.
|
Received: 29 February 2016
Published: 15 December 2016
|
Fund:National Nature Science Foundation of China |
Corresponding Authors:
LI Wei-Gang
E-mail: liweigang.luck@foxmail.com
|
|
|
|
[1] |
Qing Shao*,Tao Xu,Tatsuo Yoshino,Nan Song. Multi-objective optimization of gas metal arc welding parameters and sequences for low-carbon steel (Q345D) T-joints[J]. Chinese Journal of Iron and Steel, 2017, 24(5): 544-555. |
[2] |
Meng-xuan Guo,Kai-xiang Gao,Wu-rong Wang,Xi-cheng Wei. Microstructural evolution of Al-Si coating and its influence on high tempera-ture tribological behavior of ultra-high strength steel against H13 steel[J]. Chinese Journal of Iron and Steel, 2017, 24(10): 1048-1058. |
[3] |
Jos�� Angel BARRIOS,C��sar VILLANUEVA,Alberto CAVAZOS,Rafael COL��S. Fuzzy C-means Rule Generation for Fuzzy Entry Temperature Prediction in a Hot Strip Mill[J]. Chinese Journal of Iron and Steel, 2016, 23(2): 116-123. |
[4] |
M.A.MORADPOUR,S.H.HASHEMI,K.KHALILI. Multi-objective Optimization of Welding Parameters in Submerged Arc Welding of API X65 Steel Plates[J]. Chinese Journal of Iron and Steel, 2015, 22(9): 870-878. |
[5] |
Yang YU,Chang WANG,Lin WANG,Jin CHEN,Ya-jun HUI,Chang-ku SUN. Combination Effect of Si and P on Tertiary Scale Characteristic of Hot Rolled Strip[J]. Chinese Journal of Iron and Steel, 2015, 22(3): 232-237. |
[6] |
Xiao-chen WANG,Quan YANG,You-zhao SUN. Rectangular Section Control Technology for Silicon Steel Rolling[J]. Chinese Journal of Iron and Steel, 2015, 22(3): 185-191. |
|
|
|
|