|
|
|
| Influence of lateral displacement on strip shape during cold rolling |
| Zhong-kai Ren1,2,3 . Hong Xiao1,2 . Hong-biao Xie1,2 . Xiao Liu1,2 |
1 College of Mechanical Engineering, Yanshan University, Qinhuangdao 066004, Hebei, China
2 National Engineering Research Center for Equipment and Technology of Cold Strip Rolling, Yanshan University, Qinhuangdao 066004, Hebei, China
3 College of Mechanical Engineering, Taiyuan University of Technology, Taiyuan 030024, Shanxi, China |
|
|
|
|
Abstract The theory of metal plastic deformation is an important part of the strip shape control theories. In order to control the shape and gauge accurately during cold thin strip rolling, the mechanism of the metal lateral .ow must be revealed clearly. Therefore, the lateral displacement of thin strip was studied by the grid method. Those grids with a line thickness of 10 lm and clear boundaries were successfully manufactured on the strip surface using lithography. Then, the effects of reduction, front andback tension, and taper angle of the .rst intermediate roll on the metal lateral .ow were studied. The strip shape was calculated with and without considering the lateral displacement; furthermore, the calculations were compared with the measured results. The results show that the calculations with considering the lateral displacement are closer to the measured results. In addition, the comparison of .nite element analysis results with the experimental results indicates that the test method was reliable.
|
|
Received: 27 May 2017
Published: 05 November 2018
|
|
|
|
| Cite this article: |
|
REN Zhong-Kai,XIAO Hong,XIE Hong-Biao, et al. Influence of lateral displacement on strip shape during cold rolling[J]. Journal of Iron and Steel Research International, 2018, 25(9): 892-900.
|
|
|
|
| [1] |
Jiao LUO,Ying-gang LIU,Miao-quan LI. Three-dimensional Numerical Simulation and Experimental Analysis of Austenite Grain Growth Behavior in Hot Forging Processes of 300M Steel Large Components[J]. Chinese Journal of Iron and Steel, 2016, 23(10): 1012-1019. |
| [2] |
SHIN Jong-min,HAN Seong-ik,KIM Jong-shik. Development and Experimental Evaluation of Strip Shape Prediction Model for Sendzimir Rolling Mills[J]. Chinese Journal of Iron and Steel, 2013, 20(12): 25-32. |
| [3] |
WANG Li-tao,DENG Chen-hong,DONG Mei,SHI Li-fa,ZHANG Jian-ping. Development of Continuous Casting Technology of Electrical Steel and New Products[J]. Chinese Journal of Iron and Steel, 2012, 19(2): 1-6. |
| [4] |
ZHANG Yun,YANG Quan,WANG Xiao-chen. Control Strategies of Asymmetric Strip Shape in Six-High Cold Rolling Mill[J]. Chinese Journal of Iron and Steel, 2011, 18(9): 27-32. |
| [5] |
REN Xin-yi,DU Feng-shan,HUANG Hua-gui,ZHANG Shang-bin. Application of Improved Fuzzy Immune PID Controller to Bending Control System[J]. Chinese Journal of Iron and Steel, 2011, 18(3): 28-33. |
| [6] |
LI Hai-jun;XU Jian-zhong. Development of Strip Flatness and Crown Control Model for Hot Strip Mills[J]. Chinese Journal of Iron and Steel, 2010, 17(3): 21-21. |
|
|
|
|
2018, Vol. 25 
