|
|
Failure analysis of crevice corrosion on 304 stainless steel tube heat exchanger |
Chen Dong1, Shen Qu1, Chang-ming Fu1, Zhe-feng Zhang1 |
1 Failure Analysis Center for Materials, Institute of Metal Research, Chinese Academy of Sciences, Shenyang 110016, Liaoning, China |
|
|
Abstract The cause of the premature failure of 304 stainless steel tube heat exchanger was investigated. The unique skeleton structure inside the leakage point reveals that this is a new damage mechanism caused by a δ+γ two-phase structure and crevice corrosion. The three-dimensional structure of the leakage point was demonstrated using X-ray diffraction topography. The results of scanning electron microscope examination show the microstructure of the weld to be columnar and dendritic. It is found by electron probe microscope analysis and transmission electron microscopy that columnar dendrites consisted of γ-dendrite and an amount of δ-ferrite phases at the dendrite trunk. Simulated corrosion test results confirmed that the corrosion medium was the chloride ion. Crevice corrosion of chloride ions occurred at weld defects on the inner wall thus forming a concentration cell. Grains of columnar dendrites were then corroded by chloride ions and δ-ferrite phases on the grain boundaries were retained, which formed the particular skeleton corrosion structure. As a result, it led to leakage when the corrosion of weld occurred from the inner wall to the outer wall.
|
|
|
|
|
Cite this article: |
Chen Dong,Shen Qu,Chang-ming Fu, et al. Failure analysis of crevice corrosion on 304 stainless steel tube heat exchanger[J]. Journal of Iron and Steel Research International, 2023, 30(8): 1490-1498.
|
|
|
|
[1] |
Jia-long Tian, Guang Hu, Wei Wang, Yi-yin Shan, Zhou-hua Jiang. Torsional deformation-induced gradient hierarchical structure in a 304 stainless steel[J]. JOURNAL OF IRON AND STEEL RESEARCH,INTERNATIONAL, 2021, 28(06): 722-728. |
[2] |
Zhi-bing Chu, ? Dong Wei ? Lian-yun Jiang ? Duo Zhang ? Qing-xue Huang, ? Yu-gui Li,. Numerical model establishment and verification of cold pilgering on cycle feed rate[J]. , 2018, 25(4): 398-408. |
[3] |
ZHANG Xiang-yu,HUANG Xiao-bo,JIANG Li,MA Yong,FAN Ai-lan,TANG Bin. Antibacterial Property of Cu Modified Stainless Steel by Plasma Surface Alloying[J]. Chinese Journal of Iron and Steel, 2012, 19(4): 75-79. |
[4] |
HAN Wei,MENG Xian-ming,ZHANG Jun-bao,ZHAO Jie. Elastic Modulus of 304 Stainless Steel Coating by Cold Gas Dynamic Spraying[J]. Chinese Journal of Iron and Steel, 2012, 19(3): 73-78. |
[5] |
MENG Xian-ming,ZHANG Jun-bao,HAN Wei,ZHAO Jie. Fracture Behavior of Cold Sprayed 304 Stainless Steel Coating During Cold Rolling[J]. Chinese Journal of Iron and Steel, 2012, 19(11): 57-63. |
[6] |
XUE Zong-yu;ZHOU Sheng. Influence of PreTransformed Martensite on WorkHardening Behavior of SUS 304 Metastable Austenitic Stainless Steel[J]. Chinese Journal of Iron and Steel, 2010, 17(3): 51-55. |
|
|
|
|