宁钢2号板坯连铸机电动缸在线调宽的成功应用
袁淳安1 , 代红波2 , 王 辉1 , 王 彬2
1. 宁波钢铁公司炼钢厂, 淅江 宁波 315807 2. 衡阳镭目科技有限责任公司, 湖南 衡阳 421001
Successful application of electric actuator on-line mould width adjustment in ningbo iron and steel co.,ltd., 2# slab caster
YUAN Chun-An1 , DAI Hong-Bo2 , WANG-Hui1 , WANG Bin2
(1. Ningbo Iron and Steel Co.,Ltd., Ningbo 315807, Zhejiang, China 2. RAMON Science and Technology Co., Ltd., Hengyang 421001, Hunan, China)
摘要 描述了电动缸在线调宽在宁钢2号连铸机板坯连铸上改造过程中,通过理论计算和试验相结合,对在线调宽的软夹紧压力进行精确计算,并该结果在使用中得到验证;通过建立间隙策略模型很好的消除了机械间隙对窄边锥度的影响;软件上开发了模拟调宽功能,能够在非浇钢时,提前预演调宽过程,大大降低了调宽试验风险和试验成本。
关键词 :
关键词 板坯连铸机 ,
结晶器 ,
电动缸 ,
在线调宽 ,
间隙策略 ,
模拟调宽
Abstract :This paper describes The electric actuator on-line width adjustment control system on No.2 slab caster in Ningbo Iron & Steel Co.,Ltd. Based on theoretical calculation and experiment, get the precise calculation of the soft clamping pressure of on-line width adjustment control system, and proved in actual operation. The influence of mechanical clearance on narrow side taper is eliminated by establishing the gap strategy model. The software has developed a function of simulating width adjustment, which can simulate the whole process of width adjustment offline, greatly reduces the risk and cost of experiment.
Key words :
Key words: slab caster
mould
Electric actuator
online width adjusting
gap strategy
analogue width adjustment
收稿日期: 2017-05-16
出版日期: 2017-11-14
参考文献
[1]
刘明延 李平 栾兴家 于登龙登编 板坯连铸机-设计与计算(上册) 1990(2);
[1]
陈斌, 李海波, 季晨曦, 刘国梁, 周海忱. 浇铸参数对结晶器液面波动影响及其工业应用 [J]. 钢铁, 2022, 57(7): 86-94.
[2]
宫佳睿,刘中秋,吴颖东,姚毓超,姜玖华,李宝宽. 连铸结晶器内弥散氩气泡的瞬态运动和捕捉行为 [J]. 钢铁研究学报, 2022, 34(5): 461-469.
[3]
周秋月, 朱坦华, 张立峰, 陈威, 袁天祥, 刘珍童. 非稳态浇铸对结晶器卷渣定量影响的大涡模拟 [J]. 钢铁, 2022, 57(4): 68-78.
[4]
刘颜彬, 唐海燕, 王凯民, 马钰, 尚广浩, 张力萍, 张家泉. 水口结构对板坯结晶器液面流动行为的影响 [J]. 连铸, 2022, 41(3): 1-10.
[5]
刘同威, 张燕超, 张彩军, 翟进坡. 吹氩条件下结晶器钢渣液面波动行为 [J]. 连铸, 2022, 41(3): 18-24.
[6]
刘长伟, 邹卓明. 机器人自动加保护渣技术在宁波钢铁的应用 [J]. 连铸, 2022, 41(3): 71-75.
[7]
周干水, 张海洋, 宁曙光, 孙军, 陈阳, 肖海健. 热调宽技术在四台双流板坯连铸上的应用 [J]. 连铸, 2022, 41(3): 76-82.
[8]
李向龙, 冯胜强, 张志霄, 武光君, 张佩, 屈天鹏. 连铸坯拉速对结晶器卷渣现象的影响 [J]. 连铸, 2022, 41(2): 100-108.
[9]
邓勇, 杨利彬, 汪成义. 马钢低碳钢板坯高拉速连铸技术的应用 [J]. 连铸, 2022, 41(1): 72-77.
[10]
刘文祥, 任磊. 浸入式水口倾角对宽幅连铸结晶器内流动行为的影响 [J]. 钢铁, 2022, 57(1): 83-92.
[11]
朱苗勇. 高拉速连铸过程传输行为特征及关键技术探析 [J]. 钢铁, 2021, 56(7): 1-12.
[12]
朱立光, 张利民, 王杏娟, 张彩军, 韩毅华, 孙立根. 漏斗形结晶器液面流场物理试验与数值模拟分析 [J]. 连铸, 2021, 40(6): 2-8.
[13]
李四军, 彭永香, 李萍, 宁伟, 杜金科, 付常伟. 超薄大断面异型坯结晶器非对称流场和温度场的优化 [J]. 连铸, 2021, 40(6): 9-16.
[14]
石红燕, 吴春雷, 刘利, 田盛林, 刘晓明, 王强. 电磁旋流水口对圆坯结晶器液面波动的控制 [J]. 连铸, 2021, 40(6): 24-28.
[15]
刘斌, 王明林, 张慧, 伍旋, 于樾, 王学兵. 拉速对板坯倒角结晶器钢液流动的影响 [J]. 连铸, 2021, 40(6): 29-37.