|
|
Application of grain characteristic in analysis of
surface defects on automotive steel sheets |
JIN Xinyan1,2,BI Wenzhen1,2,WANG Li1,2 |
1. Baosteel Research Institute, Shanghai 201999, China;2. State Key Laboratory of
Development and Application Technology of Automotive Steels, Baosteel, Shanghai 201999, China |
|
|
Guide |
|
Abstract A variety of surface defects on continuous annealed or galvanized automotive steel sheets such as scratches, dents, coating pinhole, stamping orange peel, stamping streak and streaky mark were studied. The crystalline grains located in defects were observed by scanning electron microscope(SEM) and optical microscope(OM), and four types of grain characteristics were found including fine grains, coarse grains, non-recrystallized grains, and deformed grains. The results indicated that the grain characteristics at the defect position could be utilized to further determine the defect origination and reduce the scope of inspection. For the scratches or dents originated from the continuous annealing line, the local deformed grains indicated that the defect may originate in the cooling section. The local coarse grains suggested a strain-induced secondary recrystallization occurred in the ends of heating section or in the beginning of soaking section. The local fine grains meant that the defect probably occurred in the heating section, cleaning section or it might be brought by the as received cold rolled steel sheet.
|
Received: 06 April 2021
|
|
|
|
|
[1] |
DING Kai1,2, DONG Wufeng1,2, WANG Li3,4, PAN Hua3,4, LEI Ming3,4, GAO Yulai1,2 . Progress and challenge of liquid metal embrittlement in galvanized advanced high strength steel
[J]. JOURNAL OF IRON AND STEEL RESEARCH , 2022, 34(5): 399-410. |
[2] |
NI Ao1, LI Chengzhi1, ZHANG Wei2, YIN Teng3, LU Zhengdong3, XUE Zhengliang2 . Numerical simulation research on tuyere air supply characteristics of large blast furnace [J]. JOURNAL OF IRON AND STEEL RESEARCH , 2022, 34(5): 411-420. |
[3] |
BAI Jiapei1, LIU Wenqiang1, YANG Aimin1, LI Jie1, LI Daliang2, LI Fei2 . Effect of w(MgO) on strength of pellets made of local
high silicon iron powder [J]. JOURNAL OF IRON AND STEEL RESEARCH , 2022, 34(5): 421-428. |
[4] |
FAN Xiaohui, ZHU Yuan, GAN Min, JI Zhiyun, SUN Zengqing, WU Yufeng . Effect of SO2 and H2O(g) in flue gas of pellet on SCR catalytic denitrification [J]. JOURNAL OF IRON AND STEEL RESEARCH , 2022, 34(5): 429-437. |
[5] |
ZHAO Peng1,2,ZHANG Hua1,2,FANG Qing1,2,WANG Jiahui1,2, WU Guoliang1,2,NI Hongwei1,2. Numerical study on strandblocking operation of a sixstrand square billet tundish [J]. JOURNAL OF IRON AND STEEL RESEARCH , 2022, 34(5): 438-450. |
[6] |
JI Junhong,JIANG Yu,DU Hongxian,WANG Shuoshuo . Numerical simulation of influence of impellers′ shape on mixing behavior by KR method desulfurization [J]. JOURNAL OF IRON AND STEEL RESEARCH , 2022, 34(5): 451-460. |
|
|
|
|