缺口对渗氮CrNiW钢超高周疲劳特性的影响

doi:10.13228/j.boyuan.issn0449-749x.20200456

Abstract
Figure/Table
References
Related Citation (10)

Download: PDF (8160 KB) HTML (1 KB)
Export: BibTeX | EndNote (RIS)

Abstract In order to study the influence of notch sensitivity on fatigue properties of nitrided CrNiW steel,a smooth specimen and two notched specimens with concentration factor K_t=1.20 and K_t=1.55 were designed,respectively. The very high cycle fatigue tests were carried out by using nitrided CrNiW steel. The microstructure of the fatigue specimen was observed by SEM. The relationship of notch fatigue factor K_f,notch sensitivity index q and number of cycles to failure N_f were analyzed. The results show that,the case-nitriding has little effect on the improvement of fatigue strength of steel. For the smooth specimen and the notch specimen with K_t=1.20,the failure modes can be classified as surface induced failure and the interior induced failure where the defects are limited in the non-nitriding area. For the notch specimen with K_t=1.55,interior failure induced by the inhomogeneous matrix area within the nitrided layer is observed,which is a new failure characteristic. The duplex S-N property of smooth specimen is not obvious. However,there is a duplex S-N property with surface induced failure and interior induced failure as K_t=1.20,and there is a duplex S-N property only with surface induced failure which occurs in the short life regime and the VHCF regime as K_t=1.55. With the increase of K_t,the phenomenon of multiple interior crack sites is replaced by the single interior crack site,and the interior defect position gradually moves towards the surface of specimen,and the shape of fisheye first approximately exhibits the oblate with major axis at x direction,followed by the circular shape,and then the elliptical shape with major axis at y direction. The K_t has a large effect on fatigue life with surface failure,but has a little effect on fatigue life with interior failure.

Key words： notch sensitivity nitride CrNiW steel S-N curve very high cycle fatigue property

Received: 02 September 2020

	Service

	E-mail this article
	Add to my bookshelf
	Add to citation manager
	E-mail Alert
	RSS
	Articles by authors
	SUN Zhen-duo
	HOU Dong-bo
	LI Wei
	ZHANG Ming-yang

Cite this article:

SUN Zhen-duo,HOU Dong-bo,LI Wei等. Influence of notch on fatigue properties of nitrided CrNiW steel in very high cycle regime[J]. Iron and Steel, 2021, 56(3): 120-129.

URL:

http://www.chinamet.cn/Jweb_gt/EN/10.13228/j.boyuan.issn0449-749x.20200456 OR http://www.chinamet.cn/Jweb_gt/EN/Y2021/V56/I3/120

[1] 谢学涛,何柏林,金辉,等. 超声冲击对P355 NL1钢焊接接头超高周疲劳性能影响[J]. 钢铁,2017,52(11):59.(XIE Xue-tao,HE Bo-lin,JIN Hui,et al. Effects of ultrasonic impact treatment on very high cycle fatigue properties of P355 NL1 steel welded joint[J]. Iron and Steel,2017,52(11):59.)
[2] 张志军,何柏林,李力. 钢的超高周疲劳性能及其影响因素研究进展[J]. 钢铁,2016,51(10):62. (ZHANG Zhi-jun,HE Bo-lin,LI Li. Research progress on ultra-long-life fatigue properties of steel and its influencing factors[J]. Iron and Steel,2016,51(10):62.)
[3] 杨延辉,王琛,范海东,等. 100Cr6轴承钢的超高周疲劳性能研究[J]. 中国冶金,2020,30(9):41.(YANG Yan-hui,WANG Chen,FAN Hai-dong,et al. Research of ultra-high cycle fatigue property of 100Cr6 bearing steel[J]. China Metallurgy,2020,30(9):41.)
[4] 刘湘江,陈桢,惠卫军. 38MnVS非调质钢的缺口高周疲劳破坏行为[J]. 钢铁,2020,55(7):106.(LIU Xiang-jiang,CHEN Zhen,HUI Wei-jun. Notch high-cycle fatigue behavior of 38 MnVS medium-carbon forging steel[J]. Iron and Steel,2020,55(7):106.)
[5] Akiniwa Y,Miyamoto N,Tsuru H,et al. Notch effect on fatigue strength reduction of bearing steel in the very high cycle regime[J]. International Journal of Fatigue,2006,28(11):1555.
[6] QIAN G,HONG Y,ZHOU C. Investigation of high cycle and Very-High-Cycle Fatigue behaviors for a structural steel with smooth and notched specimens[J]. Engineering Failure Analysis,2010,17(7/8):1517.
[7] Burkart K,Bomas H,Zoch H W. Fatigue of notched case-hardened specimens of steel SAE 5120 in the VHCF regime and application of the weakest-link concept[J]. International Journal of Fatigue,2011,33(1):59.
[8] 闫桂玲,王弘,康国政,等. 缺口应力集中对5083-H111铝合金超高周疲劳性能的影响[J]. 西南交通大学学报,2016,51(5):944. (YAN Gui-ling,WANG Hong,KANG Guo-zheng,et al. Influence of notch stress concentration on fatigue properties of 5083-H111 aluminum alloy in very high cycle regime[J]. Journal of Southwest Jiaotong University,2016,51(5):944.)
[9] 王欣,胡云辉,曾惠元,等. 结构应力集中和表面完整性对17-4PH钢轴向疲劳性能的影响[J]. 中国表面工程,2016,29(2):111. (WANG Xin,HU Yun-hui,ZENG Hui-yuan,et al. Effects of structural stress concentration and surface integrity on axial fatigue property of 17-4 PH steel[J]. China Surface Engineering,2016,29(2):111.)
[10] 刘也川,张松,谭俊哲,等. 机械滚压对A473M 钢疲劳性能的影响[J]. 材料工程,2020,48(3):163.(LIU Ye-chuan,ZHANG Song,TAN Jun-zhe,et al. Effect of mechanical rolling on fatigue properties of A473 steel[J]. Journal of Materials Engineering,2020,48(3):163.)
[11] Suh C M,Hwang J K,Son K S,et al. Fatigue characteristics of nitrided SACM 645 according to the nitriding condition and notch[J]. Materials Science and Engineering A,2005,392(7):31.
[12] Bagherifard S,Fernandez-Pariente I,Ghelichi R,et al. Fatigue behavior of notched steel specimens with nano crystallized surface obtained by severe shot peening[J]. Materials and Design,2013,45(3):497.
[13] 吴瑛,雷丽萍,曾攀. 喷丸对H13 钢单边带缺口试样疲劳裂纹扩展行为的影响[J]. 中国表面工程,2017,30(4):117.(WU Ying,LEI Li-ping,ZENG Pan. Effects of shot peening on fatigue crack propagation behavior of single notched H13 steel specimens[J]. Chinese Surface Engineering,2017,30(4):117.)
[14] Winck L B,Ferreira J L A,Araujo J A,et al. Surface nitriding influence on the fatigue life behavior of ASTM A743 steel type CA6 NM[J]. Surface and Coatings Technology,2013,232(7):844.
[15] 宫昱滨,鲁连涛,张远彬. 气体渗氮对中碳车轴钢疲劳性能的影响[J]. 实验力学,2017,32(1):63. (GONG Yu-bin,LU Lian-tao,ZHANG Yuan-bin. Effect of gas nitriding on fatigue performance of medium carbon axle steel[J]. Journal of Experimental Mechanics,2017,32(1):63.)
[16] Limodin N,Verreman Y. Fatigue strength improvement of a 4140 steel by gas nitriding: Influence of notch severity[J]. Materials Science and Engineering A,2006,435/436(11):460.
[17] Akita M,Tokaji K. Effect of carburizing on notch fatigue behaviour in AISI 316 austenitic stainless steel[J]. Surface and Coatings Technology,2006,200(20/21):6073.
[18] Blasóna S,Rodrígueza C,Belzuncea J,et al. Fatigue behavior improvement on notched specimens of two different steels through deep rolling,a surface cold treatment[J]. Theoretical and Applied Fracture Mechanics,2017,29(12):223.
[19] LI W,YUAN H,SUN Z D,et al. Surface vs. interior failure behaviors in a structural steel under gigacycle fatigue: Failure analysis and life prediction[J]. International Journal of Fatigue,2014,64(3):42.
[20] Fan J,Mcdowell D L,Horstemeyer M F,et al. Cyclic plasticity at pores and inclusions in cast Al-Si alloys[J]. Engineering Fracture Mechanics,2003,70(10):1281.
[21] CHAI G. The formation of subsurface non-defect fatigue crack origins[J]. International Journal of Fatigue,2006,28(11):1533.
[22] Sakai T,Oguma N,Morikawa A. Microscopic and nanoscopic observations of metallurgical structures around inclusions at interior crack initiation site for a bearing steel in very high-cycle fatigue[J]. Fatigue and Fracture of Engineering Materials and Structures,2015,38(11):1305.