|
|
|
| Analysis of the thermal-force control ability under the variation of ES structure parameters in RPECT |
| Ting-song Yang1,2, Wen-quan Sun1,2, Feng-shan Du3, An-rui He1,2, Quan Yang1,2 |
1 National Engineering Research Center of Advanced Rolling and Intelligent Manufacturing, University of Science and Technology Beijing, Beijing 100083, China
2 Institute of Engineering and Technology, University of Science and Technology Beijing, Beijing 100083, China
3 College of Mechanical Engineering, Yanshan University, Qinhuangdao 066004, Hebei, China |
|
|
|
|
Abstract Thermal-force driving of roll profile electromagnetic control technology (RPECT), which can be used to adjust the roll profile, can be affected by the sequential temperature rise between the electromagnetic stick (ES) and electromagnetic control roll. Due to the limited space of ES and induction coil, the cross-sectional area of induction coil can be inevitably affected by changing the size of the ES induction zone, which can further change the energy input under the same electromagnetic parameters, the temperature rising effect and the bulging ability. To investigate this phenomenon, the effects of the radius of the induction zone on the thermal-force contribution ratio, the heating ability of ES and the temperature distribution were analyzed through an electromagnetic-thermal-structural finite element model. To ensure that the results are applicable to RPECT, the thermal energy conversion ability and thermal-force roll crown control ability under different lengths of the induction zone were analyzed. It was found that whether the current density regulation mode or the current frequency regulation mode is adopted, the cases with 20 or 25 mm radius of the induction zone have the great thermal energy conversion ability and the good thermal-force roll crown control ability. The reasonable adjustment of the length of the induction zone can reduce the radius required for the maximum energy efficiency regulation. Combined with the results of the simulation analysis, the optimization of ES based on the control ability maximization requirement is achieved, which provides the base for the design and configuration of ES in RPECT.
|
|
Received: 20 November 2022
Published: 25 January 2024
|
|
|
|
| Cite this article: |
|
Ting-song Yang,Wen-quan Sun,Feng-shan Du, et al. Analysis of the thermal-force control ability under the variation of ES structure parameters in RPECT[J]. Journal of Iron and Steel Research International, 2024, 31(1): 224-236.
|
|
|
|
|
|
|
2024, Vol. 31 
