Abstract：The bolted structure were adopted usually in the caster tundish stopper mechanism, the stopper were fixed and adjusted by usually adopts the straight slot structure in the clamp arm , but the structure was easy to loose, then stopper slip accident would happened. The installation method of the stopper was improved, the notch of clamp arm was instead with L type, at the same time the boss washer was installed in the stopper, the stopper route was limited and fixed by the difference of turning radius. These ensure that the stopper will not fall off. The reliable implementing basis for the same type stopper installation method is introduced.
沈 康. 连铸塞棒紧固失效原因分析及措施[J]. 中国钢铁期刊网, 2015, 34(2): 51-54.
SHEN Kang. Failure analysis and measures of continuous casting stopper rod fastening. Chinese Journal of Iron and Steel, 2015, 34(2): 51-54.
2015, Vol. 34 
