Abstract：The F-EMS has played an important role in quality improvement for billet center， and the installation location of the F-EMS is the basis of effective functioning of the F-EMS. In the production process， the F-EMS should be installed in the location where the non-solidification rate is 25%-35%， which is often determined through the rivet pin shooting experiments. In the rivet pin shooting experiments for high carbon steel， the steel pins are often not melted， resulting in a difficulty in distinguishing the solid-liquid phase region， and the installation is not accurate. Good results have been achieved by using a suitable material to make steel pins and successfully applied into the rivet pin shooting experiments for high carbon steel.
刘 筠，刘 顺. 高碳钢射钉试验钢钉材料的研究[J]. 中国钢铁期刊网, 2017, 36(1): 51-53.
LIU Jun，LIU Shun. Research on material of steel pins in the rivet pin shooting experiments for high carbon steel. Chinese Journal of Iron and Steel, 2017, 36(1): 51-53.
2017, Vol. 36 
