BaO对铝酸盐熔渣微观结构和宏观性能的影响

doi:10.13228/j.boyuan.issn1005-4006.20200154

Abstract
Figure/Table
References
Related Citation (15)

Download: PDF (707 KB) HTML (0 KB)
Export: BibTeX | EndNote (RIS)

Abstract In order to explore the influence mechanism of the non-reactive component BaO on the microstructure stability and macroscopic properties of aluminate slag, the influence of BaO on the melting temperature, viscosity, electrical conductivity and microstructure of aluminate slag (w(CaO)/w(Al₂O₃)=1.3) was studied by combining hemisphere melting temperature test, rotating viscometer, conductivity tester with four-electrode technique and infrared spectrum experiment. The results show that, with the increase of BaO content, BaO simplifies the microstructure network structure of aluminate slag, and the degree of polymerization of the aluminate slag structure decreases. Because the melting temperature of the slag changes very little within the composition range of this test, it shows that the degree of superheat has little effect on the viscosity of the slag, that is, the viscosity of the slag is mainly affected by the degree of polymerization. Due to the increase of the Ba²⁺ cation concentration and the decrease of the polymerization degree of the slag network structure, the conductivity of slag increases. In addition, with the increase of BaO content, the breaking temperature on the viscositie-temperature curve decreases, indicating that BaO improves the glass properties of the slag at low temperature. Therefore, BaO is beneficial to the improvement of the lubricating properties of aluminate-based mold slag.

Key words： aluminate slag microstructure melting temperature viscosity electrical conductivity breaking temperature

Received: 28 December 2020

	Service

	E-mail this article
	Add to my bookshelf
	Add to citation manager
	E-mail Alert
	RSS
	Articles by authors
	SHENG Guang-ye
	YANG Wen
	ZHAO Ling
	LIAO Zhi-you
	WU Ting

Cite this article:

SHENG Guang-ye,YANG Wen,ZHAO Ling等. Effect of BaO on microstructure and properties of aluminate slag[J]. CONTINUOUS CASTING, 2021, 40(2): 14-18.

URL:

http://www.chinamet.cn/Jweb_lz/EN/10.13228/j.boyuan.issn1005-4006.20200154 OR http://www.chinamet.cn/Jweb_lz/EN/Y2021/V40/I2/14

[1]	ZHANG Z, WEN G, TANG P, et al. The influence of Al2O3/SiO2 ratio on the viscosity of mold fluxes[J]. ISIJ International, 2008, 48(6):739.
[2]	LU B, CHEN K, WANG W, et al. Effects of Li2O and Na2O on the crystallization behavior of lime-alumina-based mold flux for casting high-Al-steels[J]. Metallurgical and Materials Transactions:B, 2014, 45(4):1496.
[3]	CHEN G J, HE S P, WANG Q. Dissolution behavior of Al2O3 into tundish slag for high-Al steel[J]. Journal of Materials Research and Technology, 2020, 9(5):11311.
[4]	ZHANG S D, LI M, HE S P, et al. Effect of substituting Na2O for SiO2 on the non-isothermal crystallization behavior of CaO-BaO-Al2O3 based mold fluxes for casting high Al steels[J].Ceramics International, 2019, 45(9):11296
[5]	PIAO Z L, ZHU L G, WANG X G, et al. Effect of BaO on the viscosity and structure of fluorine-free calcium silicate-based mold flux[J]. Journal of Non-Crystalline Solids, 2020, 542:120111.
[6]	KIM H, KIM W H, SOHN I, et al. The effect of MgO on the viscosity of the CaO-SiO2-20wt% Al2O3-MgO slag system[J]. Steel Research International, 2010, 81: 261.
[7]	刘克, 韩毅华, 杨帆, 朱立光. MgO对CaO-Al2O3基四元系保护渣熔渣微结构的影响[J]. 钢铁, 2020, 55(5): 52.
[8]	ZHU J H, HOU Y, ZHENG W W, et al. Influences of Na2O, K2O and Li2O additions on electrical conductivity of CaO-SiO2-(Al2O3) melts[J]. ISIJ International, 2019, 59:1947.
[9]	巨建涛, 吕振林, 焦志远. CaF2-SiO2-Al2O3-CaO-MgO五元渣系的电导率[J]. 钢铁研究学报2012, 24(8): 27.
[10]	朱立光, 袁志鹏, 肖鹏程, 等. 低碳钢薄板坯高速连铸保护渣研究与优化[J]. 钢铁, 2020, 55(11): 65.
[11]	YAN W, CHEN W, YANG Y, et al. Effect of CaO/Al2O3 ratio on viscosity and crystallisation behaviour of mould flux for high Al non-magnetic steel[J]. Ironmaking and Steelmaking, 2015, 42: 698.
[12]	Wang W, Blazek K, Cramb A, et al. A study of the crystallization behavior of a new mold flux used in the casting of transformation-induced-plasticity steels[J]. Metallurgical and Materials Transactions:B, 2007, 39: 66.
[13]	朱立光, 张晓仕, 王杏娟, 等. 高钛焊丝钢CaO-Al2O3基专用保护渣熔化特性分析[J]. 中国冶金, 2020, 30(10): 9.
[14]	吴婷. 低反应性连铸保护渣熔体的微结构特征及宏观性能研究[D].重庆:重庆大学,2017.
[15]	ZHANG G H, CHOU K C. Correlation between viscosity and electrical conductivity of aluminosilicate melts[J]. Metallurgical and Materials Transactions:B, 2012, 43: 849.
[16]	ZHANG G H, ZHENG W W, JIAO S, et al. Influences of Na2O and K2O additions on electrical conductivity of CaO-SiO2-(Al2O3) melts[J]. ISIJ International, 2017, 57: 2091.
[17]	LI Z R, YOU X C, LI M, et al. Effect of substituting CaO with BaO and CaO/Al2O3 ratio on the viscosity of CaO-BaO-Al2O3-CaF2-Li2O mold flux system[J]. Metals, 2019, 9(2):142.
[18]	李婷, 刘海啸, 侯忠霖.无氟连铸保护渣导电性能的实验研究[J]. 材料热处理学报, 2013.32(2):14.
[19]	HUANG X H, LIAO J L, ZHENG K, et al. Effect of B2O3 addition on viscosity of mould slag containing low silica content[J]. Ironmaking and Steelmaking, 2014, 41(1): 67.
[20]	Hess P C, Wood M I. Aluminum coordination in metaaluminous and peralkaline silicate melts[J]. Contributions to Mineralogy and Petrology, 1982, 81: 103.
[21]	Mills K C, Hayashi M, Wang L. The structure and properties of silicate slags[J]. Treatise on Process Metallurgy, 2014, 1: 149.
[22]	WANG Z, SOHN I. Effect of substituting CaO with BaO on the viscosity and structure of CaO-BaO-SiO2-MgO-Al2O3 slags[J]. Journal of the American Ceramic Society, 2018, 101: 4285.
[23]	迟景灏,甘永年.连铸保护渣[M].沈阳:东北大学出版社,1992.