1. School of Metallurgical and Ecological Engineering, University of Science and Technology Beijing, Beijing 100083, China 2. Research Institute of Baoshan Iron and Steel Co., Ltd., Shanghai 201900, China
Abstract:Lump coals were used in COREX process as the mainly fuel, but it was still necessary to feed a certain amount of coke to support burden and maintain adequate char bed permeability in melter gasifier. Tuyere coke samples were obtained by means of tuyere probing technology. Then, particle size analysis, microstructure analysis, permeability analysis and determination of the hot performance of tuyere coke were undertaken to investigate coke degradation and behavior of lump coals. Results show that larger particles (>10mm) of tuyere coke samples are mostly from charged coke deterioration and the smaller ones (<10mm) are mostly from lump coal pyrolysis. Moreover, reducing gases produced by lump coal combustion are considered to promote solution loss reaction leading to coke degradation. The physical and high temperature properties of char are inferior to that of charged cokes. The mainly parameter influencing char bed permeability is the char deterioration. Finally, combined with the former results, several measures are proposed to decrease the energy consumption of COREX process.
收稿日期: 2012-05-17
出版日期: 2013-02-06
引用本文:
湛文龙,吴铿,徐万仁,刘起航 任海亮,吴小辉. COREX熔融气化炉中块煤裂化现象[J]. 钢铁, 2013, 48(1): 20-23.
ZHAN Wen-long,WU Keng,XU Wan-ren,LIU Qi-hang,REN Hai-liang,WU Xiao-hui. Lump Coals Cracking in COREX Melter Gasifier. Iron and Steel, 2013, 48(1): 20-23.
A Eberle,D Siuka,C Behm,et al.COREX技术的现状及最新进展[J].钢铁,2003,38(10):68-71
[7]
A Eberle,D Siuka,C Behm,et al.COREX技术的现状及最新进展[J].钢铁,2003,38(10):68-71
[8]
P Prachethan Kumar,SC. Barman,B.M. Reddy and V. R. Sekhar. .Raw materials for Corex and their influence on furnace performance[J].Ironmaking and Steelmaking,2009,36(2):87-90
[8]
P Prachethan Kumar,SC. Barman,B.M. Reddy and V. R. Sekhar. .Raw materials for Corex and their influence on furnace performance[J].Ironmaking and Steelmaking,2009,36(2):87-90