分层供热富氢烧结关键技术探索与研究

doi:10.13228/j.boyuan.issn0449-749x.20210349

摘要
图/表
参考文献
相关文章 (13)

全文: PDF (3185 KB) HTML (1 KB)
输出: BibTeX | EndNote (RIS)

摘要中国提出2030年碳达峰、2060年碳中和的“双碳”战略以缓解温室效应带来的环境问题。钢铁是仅次于火电的国内第二碳排放大户,作为钢铁行业中的核心环节,烧结工序的碳减排已是必然趋势。常规烧结工艺中,料层中固体颗粒燃料难准确满足“自蓄热效应”要求的“上多下少”的分布要求,导致料层内部供热不均、成矿质量差、能效低下,且易出现微观局部还原性气氛,对烧结成矿和烟气中CO增多造成负面影响,制约了烧结节能减碳水平的提升。对此,作者研究了燃料形态、燃料分布对烧结的影响规律,提出了“分层供热富氢烧结”理念,阐述了厚料层烧结条件下料层上、中、下各层不同的气固组合供热方法,即顶层依靠富氧点火耦合固体燃料供热、上中层依靠富氢燃气喷加耦合固体燃料供热,下层依靠水蒸气喷加耦合固体燃料供热,同时探明了对应该方法的分层供热低碳烧结机理,详细阐述了富氧点火耦合固体燃料顶层供热、富氢燃气喷加耦合固体燃料中上层供热、水蒸气喷加耦合固体燃料下层供热等关键技术及其技术效果,并对应用上述技术可能出现的烧结过湿层恶化问题提出了解决办法。通过这些技术的集成应用,可以大幅降低烧结工序能耗,减少烧结工序碳消耗、碳排放及其他污染物排放,并改善烧结矿质量。

	服务

	把本文推荐给朋友
	加入我的书架
	加入引用管理器
	E-mail Alert
	RSS
	作者相关文章
	叶恒棣
	周浩宇
	王业峰
	李谦
	卢兴福
	刘前

关键词 ：低碳烧结, 分层供热, 富氢燃料, 蒸汽, 强力混合

Abstract：In order to manage the environmental problem caused by greenhouse effect, China aims to peak its carbon dioxide emissions before 2030 and achieve carbon neutrality by 2060. The iron and steel industry ranks second just after the thermal power industry in terms of the carbon emission. Therefore, reducing carbon emission in iron ore sintering is an irresistible trend. In the conventional sintering, it is hard for the solid fuel particles to disperse more in the upper bed and less in the lower bed which is essential due to the heat auto-accumulation effect. Consequently, it is inevitable that the reducing atmosphere is locally present which brings about extra CO in the flue gas and adverse impacts on the sintering process, and the uneven heat pattern impairs the sinter quality and the energy efficiency. All these restrict the improvement of energy-saving and low-carbon emission in sintering process. Based on the analysis of the effects of the fuel form and fuel distribution on the sintering process, the "multi-layer heat supplying and H₂-rich sintering" idea was proposed, which provided a new heat supplying method for upper, middle and lower layer in deep bed sintering condition. With the new method, the upper bed is heated up by the oxygen-rich ignition and solid fuel combustion, the middle bed by the combustion of H₂-rich gas and solid fuel while the lower bed by the steam injection and solid fuel combustion. The low carbon combustion mechanism as well as the key technologies of the new method were elaborated. The solution to the possible deterioration of the wet layer in the application of the technologies was also put forward. The integration application of these technologies would help to reduce energy cost, carbon as well as other pollutants emission,and improve the sinter quality.

Key words： low carbon sintering multi-layer heat supplying H₂-rich fuel steam intensive mixer

收稿日期: 2021-06-11

引用本文:

叶恒棣, 周浩宇, 王业峰, 李谦, 卢兴福, 刘前. 分层供热富氢烧结关键技术探索与研究[J]. 钢铁, 2021, 56(12): 134-141. YE Heng-di, ZHOU Hao-yu, WANG Ye-feng, LI Qian, LU Xing-fu, LIU Qian. Exploration and research on key technologies of multi-layer heat supplying and H₂-rich sintering[J]. Iron and Steel, 2021, 56(12): 134-141.

链接本文:

http://www.chinamet.cn/Jweb_gt/CN/10.13228/j.boyuan.issn0449-749x.20210349 或 http://www.chinamet.cn/Jweb_gt/CN/Y2021/V56/I12/134

[1] 李新创,李冰,霍咚梅,等. 推进中国钢铁行业低碳发展的碳排放标准思考[J].中国冶金,2021,31(6):1.(LI Xin-chuang,LI Bing,HUO Dong-mei,et al. Concerns on drafting carbon emission standard for improvement of China′s iron and steel industry with sustainable development[J]. China Metallurgy,2021,31(6):1.)
[2] 唐先觉. 论铁矿烧结减排CO₂的途径[C]//2009年度全国烧结球团技术交流年会. 长沙:中冶长天国际工程有限责任公司,2009:1.(TANG Xian-jue. Discussions on methods of reducing CO₂ in iron ore sintering[C]//2009′s Annual Conference on Sinterin and Pelleting Technical Communication. Changsha:CIE,2009:1.)
[3] 王兆才,刘臣,李继淦,等. 烧结烟气CO_x的生成机理及减排措施[J]. 烧结球团,2021,46(1):14.(WANG Zhao-cai,LIU Chen,LI Ji-gan,et al. Generation mechanism and emission reduction measures of CO_x in sintering flue gas[J]. Sintering and Pelletizing,2021,46(1):14.)
[4] 胡浪,何传超,罗国民. 国内烧结节能技术发展趋势研究[J]. 冶金能源,2021,40(1):13.(HU Lang,HE Chuan-chao,LUO Guo-min. Research on the development trend of sintering energy saving technology in China[J]. Energy for Metallurgical Industry,2021,40(1):13.)
[5] 韩记江. 配加落地烧结矿对高炉冶炼影响[J]. 冶金能源,2021,40(3):32.(HAN Ji-jiang. Influence of addition stocking sinter on blast furnace smelting[J]. Energy for Metallurgical Industry,2021,40(3):32.)
[6] 王静波,李发展,高雷. 降低工序能耗的生产实践[J]. 冶金能源,2003(6):12.(WANG Jing-bo,LI Fa-zhan,GAO Lei. Productive practice of reducing energy consumption in the working procedure[J]. Energy for Metallurgical Industry,2003(6):12.)
[7] 姜涛. 烧结球团生产技术手册[M]. 北京:冶金工业出版社,2014.(JIANG Tao. Techanical Manual of Sintering and Pelleting[M]. Beijing:Metallurgical Industry Press,2014.)
[8] 叶恒棣. 钢铁烧结烟气全流程减排技术[M]. 北京:冶金工业出版社,2019.(YE Heng-di. Flue Gas Full-process Emission Reduction Technology for Sintering of Iron and Steel[M]. Beijing: Metallurgical Industry Press, 2019.)
[9] 肖扬,翁得明. 烧结生产技术[M]. 北京:冶金工业出版社,2013.(XIAO Yang,WENG De-ming. Sintering Production Technology[M]. Beijing:Metallurgical Industry Press,2013.)
[10] 刘前,王业峰,周浩宇,等. 烧结富氧点火过程的化学动力学数值模拟[C]//第十六届中国CAE工程分析技术年会. 湖州:中国力学学会产学研工作委员会,2020.(LIU Qian,WANG Ye-feng,ZHOU Hao-yu,et al. A numerical simulation of the chemical dynamics of sintering oxygen-rich ignition processes[C]//The 16th Annual Meeting of CAE Engineering Analysis Technology in China. Huzhou:Chinese Society of Theoretical and Applied Mechanics,2020.)
[11] 刘前,周浩宇,裴元东,等. 富氧条件对低热值燃气烧结点火的影响[J]. 中国冶金,2021,31(7):57.(LIU Qian,ZHOU Hao-yu,PEI Yuan-dong,et al. Effect of oxygen enriched conditions on sintering ignition of low calorific value gas[J]. China Metallurgy,2021,31(7):57.)
[12] 叶恒棣,周浩宇,王兆才,等. 高配比富氢燃料烧结技术研究及展望[J]. 烧结球团,2020,45(5):1.(YE Heng-di,ZHOU Hao-yu,WANG Zhao-cai,et al. Research and prospect of high proportion hydrogen-rich fuel sintering technology[J]. Sintering and Pelletizing,2020,45(5):1.)
[13] HUANG Xiao-xian,FAN Xiao-hui,JI Zhi-yun,et al. Investigation into the characteristics of H₂-rich gas injection over iron ore sintering process:Experiment and modelling[J]. Applied Thermal Engineering,2019,36(5):38.
[14] 周浩宇,范晓慧,李谦,等. 氢系气体喷吹对烧结污染物释放的影响规律[J]. 东北大学学报(自然科学版),2021,42(2):260.(ZHOU Hao-yu,FAN Xiao-hui,LI Qian,et al. Effects of hydrogen-based gas injection on the release of typical pollutants in the sintering process[J]. Journal of Northeastern University(Natural Science),2021,42(2):260.)
[15] 刘天新,沈青. 水蒸气助燃机理的研究与应用[J]. 中国能源,1995(10):20.(LIU Tian-xin,SHEN Qing. Researches and applications of the mechanism of combustion supporting by the steam[J]. Energy of China,1995(10):20.)
[16] FAN Xiao-hui,YU Zhi-yuan,GAN Min,et al. Appropriate technology parameters of iron ore sintering process with flue gas recirculation[J]. ISIJ International,2014,54(11):66.
[17] 裴元东,史凤奎,吴胜利,等. 烧结料面喷洒蒸汽提高燃料燃烧效率研究[J]. 烧结球团,2016,41(6):16.(PEI Yuan-dong,SHI Feng-kui,WU Sheng-li,et al. Research on spraying steam on surface of sintering material bed to increase fuel combustion efficiency[J]. Sintering and Pelleting,2016,41(6):16.)
[18] 范晓慧,张一雄,季志云,等. 强力混合对高比例精矿烧结的影响及机制[J]. 钢铁研究学报,2021,33(1):25.(FAN Xiao-hui,ZHANG Yi-xiong,JI Zhi-yun,et al. Effect and mechanism of intensive mixing on sintering with high proportion iron ore concentrate[J]. Journal of Iron and Steel Research,2021,33(1):25.)
[19] 叶恒棣. 烧结球团节能减排先进技术[M]. 北京:冶金工业出版社,2020.(YE Heng-di, Advanced Technology of Energy Saving and Emission Reduction for Sintering and Relletizing[M]. Beijing: Metallurgical Industry Press, 2020.)
[20] 卢兴福,付森,刘克俭,等. 立式强力混合机混合过程仿真及工业实验研究[J]. 烧结球团,2017,42(3):59.(LU Xing-fu,FU Sen,LIU Ke-jian,et al. Numerical simulation and industrial experiment for vertical intensive mixer[J]. Sintering and Pelleting,2017,42(3):59.)