|
|
Effect of trace boron on corrosion resistance of rust layer of highstrength low-alloy steel in 3.5 wt.% NaCl solution |
Yan-hui Hou1,2, Ze-kun Xu1,2, Guang-qiang Li1,2 |
1 The State Key Laboratory of Refractories and Metallurgy, Wuhan University of Science and Technology, Wuhan 430081, Hubei, China 2 Key Laboratory for Ferrous Metallurgy and Resources Utilization of Ministry of Education, Wuhan University of Science and Technology, Wuhan 430081, Hubei, China |
|
|
Abstract The influence mechanism of trace boron on the corrosion resistance of high-strength low-alloy (HSLA) steel in a simulated marine environment was studied by combining first-principles calculation with experiment. The effect of boron on the corrosion properties and corrosion morphology of the rust layer formed on the surface of HSLA steel was studied by means of corrosion weightlessness method, polarization curve, scanning electron microscopy (SEM) and X-ray diffraction (XRD) technique. The mass loss measurements and polarization curves revealed that the corrosion resistance of HSLA steel is improved by adding trace boron. XRD and SEM results show that the rust layer is produced by α-FeOOH (the main protective phase), Fe3O4 and γ-FeOOH, and boron contributes to stability of α-FeOOH. Based on the first-principles calculation, the solid solution of B atom in the corrosion product is beneficial to the fixation of Cl atom and to the reduction of the corrosion of Cl atom to the steel matrix.
|
|
|
|
|
Cite this article: |
Yan-hui Hou,Ze-kun Xu,Guang-qiang Li. Effect of trace boron on corrosion resistance of rust layer of highstrength low-alloy steel in 3.5 wt.% NaCl solution[J]. Journal of Iron and Steel Research International, 2023, 30(10): 2080-2090.
|
|
|
|
[1] |
Wen-jiao Zhang, Yan-li Wang. Performance of TiC coating prepared by in situ conversion of organic carbon film on 316L bipolar plate[J]. JOURNAL OF IRON AND STEEL RESEARCH,INTERNATIONAL, 2023, 30(8): 1562-1573. |
[2] |
Hai-hui Zhang, Hui-hui Xiong, Jing Qin, Jian-bo Zhang. Mechanism of ferrite nucleation induced by Y2O2S inclusion in low carbon steel[J]. JOURNAL OF IRON AND STEEL RESEARCH,INTERNATIONAL, 2023, 30(6): 1291-1299. |
[3] |
Zi-tian Zhang, Jing-jing Wang, Wei Liu, Xiao-gang Lu. Simulation of BCC dissolution in Fe–Cr–Ni system by ICME[J]. JOURNAL OF IRON AND STEEL RESEARCH,INTERNATIONAL, 2023, 30(4): 660-676. |
[4] |
Yang Li, Chang-yong Chen, Qi Wang, Hao Yang, Shuai Ma, Meng Sun, Zhou-hua Jiang. Effect of magnesium on microstructure and properties of 440C stainless bearing steel melted under pressurized conditions[J]. JOURNAL OF IRON AND STEEL RESEARCH,INTERNATIONAL, 2023, 30(4): 808-824. |
[5] |
Dai-wei Yang, Wei Wang, Jing-xuan Li, Xu-heng Chen, Peng-fei Chen. Effect of Al2O3/SiO2 ratio on morphology of complex calcium ferrite[J]. JOURNAL OF IRON AND STEEL RESEARCH,INTERNATIONAL, 2023, 30(10): 1921-1928. |
[6] |
Jun-chen Li, Meng-yuan Ye, Rui-dong Li, Xing-run Chen. Effect of microstructure variation on corrosion properties of as-cast 0Cr23Ni13 stainless steel at high strain rate of hot compression[J]. JOURNAL OF IRON AND STEEL RESEARCH,INTERNATIONAL, 2023, 30(10): 2091-2100. |
|
|
|
|