|
|
|
| Calculation of Relative Parameters of Tail End Pinch Rollers |
| CHEN You-xin1,YANG Yi-bing2 |
1.CCTEC Engineering Co., Ltd., Ma’anshan 243005,Anhui,China
2. Electric Furnace Factory，Nanjing Iron and Steel United Co.，Ltd., Nanjing 210035, Jiangsu,China |
|
|
|
|
Abstract The pressing force and the driven moment of the tail end pinch rollers were calculated.At the same time, the results of the calculation in detail were analyzed. The right pressing force was the key for guaranteeing the safety and efficiency of the tail end pinch rollers.
|
|
Received: 01 April 2011
Published: 16 January 2012
|
|
|
|
| [1] |
Fan Qian, Hua-long Li, Wen-gang Yang, Hai-rong Guo, Guo-qi Liu, Hong-xia Li, Bei-yue Ma. Corrosion resistance of BN–ZrO2 ceramics with different additives by molten steel[J]. JOURNAL OF IRON AND STEEL RESEARCH,INTERNATIONAL, 2022, 29(7): 1101-1109. |
| [2] |
ZHANG Xiang，XIE Qinghua，NI Peiyuan，LI Ying. Flow behavior of molten steel in SEN during fullnozzle selfswirling flow continuous casting[J]. JOURNAL OF IRON AND STEEL RESEARCH , 2022, 34(7): 629-638. |
| [3] |
ZHAO Xianjiu1,2，ZHANG Jieyu2,3，LI Chuanjun2,3. Analysis of formation mechanism about Ca-Mg-Al spineltype inclusions in cold thin rolling sheet[J]. JOURNAL OF IRON AND STEEL RESEARCH , 2022, 34(7): 664-671. |
| [4] |
SHANG Ting-rui, WANG Wei-ling, KANG Ji-bai, ZHU Miao-yong, LUO Sen. In situ observation of solidification under transient and average cooling rate of 20CrMnTi continuous casting[J]. Iron and Steel, 2022, 57(7): 73-85. |
| [5] |
CHEN Bin, LI Hai-bo, JI Chen-xi, LIU Guo-liang, ZHOU Hai-chen. Influence of casting parameters on level fluctuations and its industrial application[J]. Iron and Steel, 2022, 57(7): 86-94. |
| [6] |
KANG Yong-lin, ZHU Guo-ming, JIANG Min, WANG Guo-lian, LIU Peng-tao, XU Hai-wei, XIE Cui-hong, WEI Yun-fei, SHEN Kai-zhao, LIU Yang. Slab continuous casting by big roll heavy reduction and extra thick plate rolled by low compression ratio[J]. Iron and Steel, 2022, 57(7): 95-105. |
|
|
|
|
2012, Vol. 31 
