并罐式无钟炉顶装料模式对料面炉料分布的影响

徐文轩; 程树森; 牛群; 赵国磊; 陈艳波

doi:10.13228/j.boyuan.issn0449-749x.20170148

钢铁 ›› 2017, Vol. 52 ›› Issue (12) : 8-15. DOI: 10.13228/j.boyuan.issn0449-749x.20170148

原料与炼铁

并罐式无钟炉顶装料模式对料面炉料分布的影响

徐文轩¹，程树森¹，牛群¹，赵国磊¹，陈艳波²

作者信息 +

Effects of charging patterns of bell-less top blast furnace with two parallel hoppers on burden distribution of stock surface

徐文轩¹，程树森¹，牛群¹，赵国磊¹，陈艳波²

Author information +

文章历史 +

摘要

为研究装料模式对并罐高炉料面炉料分布的影响，建立了国内某5 500 m3实际高炉并罐式无钟炉顶系统全模型，利用离散单元法分别对矿（A）-矿（B）-焦和矿-焦两种装料模式下炉料从矿焦槽运动至料面全过程进行数值计算，对比分析了装料模式对料面炉料分布的影响。结果表明，由于A矿与B矿布入料面时落点轨迹不重合，导致两种装料模式下料面炉料分布不同。在料面径向上，装料模式对料面矿石体积分布和矿焦比分布影响较小。在料面周向上，矿-矿-焦装料模式和矿-焦装料模式下料面矿石体积分布标准差分别为0.133和0.147，矿-矿-焦装料模式和矿-焦装料模式下料面矿焦比分布标准差分别为0.074和0.086，矿-矿-焦装料模式下矿石体积分布和矿焦比分布更均匀。

Abstract

In order to investigate the influence of charging patterns on the burden distribution of the stock surface in blast furnace with two parallel hoppers， the full model of bell-less top system with two parallel hoppers in actual 5 500 m3 blast furnace was established， and the motions of burden materials in the cases of the ore （A）-ore （B）-coke charging pattern and the ore-coke charging pattern were calculated by Discrete Element Method， respectively. The effects of charging patterns on the burden distribution of the stock surface were comparative and analyzed. The results show that the burden distribution of the stock surface is different in two different charging patterns， because the burden falling trajectory is not coincident while the ore-A and ore-B are charged into the stock surface. In the radial direction of the stock surface， the influence of charging patterns on the ore volume distribution and the ore/coke ratio distribution of the stock surface is negligible. In the circumferential direction of the stock surface， the standard deviation of the ore volume distribution of the stock surface in the ore-ore-coke charging pattern and the ore-coke charging pattern is 0.133 and 0.147， respectively， and the standard deviation of the ore/coke ratio distribution of the stock surface in the ore-ore-coke charging pattern and the ore-coke charging pattern is 0.074 and 0.086， respectively. The ore volume distribution and the ore/coke ratio distribution of the stock surface is more uniform in the ore-ore-coke charging pattern.

关键词

并罐 / 装料模式 / 炉料分布 / 离散单元法

Key words

Parallel hoppers / Charging pattern / Burden distribution / Discrete Element Method

图表

引用本文

EndNote

Ris (Procite)

Bibtex

导出引用

徐文轩, 程树森, 牛群, 等. 并罐式无钟炉顶装料模式对料面炉料分布的影响[J]. 钢铁, 2017, 52(12): 8-15 https://doi.org/10.13228/j.boyuan.issn0449-749x.20170148

XU Wen-Xian, CHENG Shu-Sen, NIU Qun, et al. Effects of charging patterns of bell-less top blast furnace with two parallel hoppers on burden distribution of stock surface[J]. Iron and Steel, 2017, 52(12): 8-15 https://doi.org/10.13228/j.boyuan.issn0449-749x.20170148

参考文献

[1]滕召杰，程树森，赵国磊.并罐式无钟炉顶布料料面中心研究[J].钢铁研究学报, 2014, 26(06):5-10 [2]TENG Zhao-jie, CHENG Shu-sen, ZHAO Guo-lei.Research of the center of the burden surface for a bell-less top blast furnace with parallel hoppers[J].Journal of Iron and Steel Research, 2014, 26(06):5-20 [3]马富涛.高炉偏析布料料面的数值模拟[J].钢铁, 2013, 48(08):19-23 [4]MA Fu-tao.Simulation on Charge Level for BF Segregation Feeding[J].Iron and Steel, 2013, 48(08):19-23 [5]杜鹏宇，程树森，滕召杰.并罐式无钟炉顶布料蛇形偏料的研究[J].北京科技大学学报, 2011, 33(4):479-485 [6]DU Peng-yu, CHENG Shu-sen, TENG Zhao-jie.Research of snakelike deviation in the burden distribution of a parallel-hopper bell-less top[J].Journal of University of Science and Technology Beijing, 2011, 33(4):479-485 [7]LIANG D, YU Y W, BAI C G, et al.Effect of burden material size on blast furnace stockline profile of bell-less blast furnace[J].Ironmaking & Steelmaking, 2009, 36(3):217-221 [8]YU Y W, BAI C G, ZHANG Z R, et al.Theoretical calculation and validation of burden trajectory in bell-less top blast furnace[J].Ironmaking & Steelmaking, 2009, 36(7):505-508 [9]NAG S, KORANNE V M.Development of material trajectory simulation model for blast furnace compact bell-less top[J].Ironmaking & Steelmaking, 2013, 36(5):371-378 [10]REN T Z, JIN X, BEN H Y, et al.Burden Distribution for Bell-Less Top With Two Parallel Hoppers[J].Journal of Iron and Steel Research, International, 2006, 13(2):14-17 [11]TENG Z J, Cheng S S, Du P Y, et al.Mathematical model of burden distribution for the bell-less top of a blast furnace[J].International Journal of Minerals, Metallurgy, and Materials, 2013, 20(7):620-626 [12]XU J, WU S L, KOU M Y, et al.Circumferential burden distribution behaviors at bell-less top blast furnace with parallel type hoppers[J].Applied Mathematical Modelling, 2011, 35(3):1439-1455 [13]ZHAO G L, CHENG S S, XU W X, et al.Comprehensive Mathematical Model for Particle Flow and Circumferential Burden Distribution in Charging Process of Bell-less Top Blast Furnace with Parallel Hoppers[J].ISIJ International, 2015, 55(12):2566-2575 [14]ZHAO H T, ZHU M H, DU P, et al.Uneven Distribution of Burden Materials at Blast Furnace Top in Bell-less Top with Parallel Bunkers[J].ISIJ International, 2012, 52(12):2177-2185 [15]YU Y W, SAXéN H.Segregation behavior of particles in a top hopper of a blast furnace[J]., 2014, 262:233-241 [16]邱家用，张建良，孙辉，等.并罐式无钟炉顶装料行为的离散元模拟及实验研究[J].应用数学和力学, 2014, 35(06):598-609 [17]QIU Jia-yong, ZHANG Jian-liang, SUN Hui, et al.DEM simulation and experiment investigation of burden distribution in the parallel-hopper bell-less top blast furnace[J].Applied Mathematics and Mechanics, 2014, 35(06):598-609 [18]邱廷省，吴紧钢，邱小平，等.无料钟并罐装料过程的离散单元模拟[J].计算机与应用化学, 2015, 32(05):527-533 [19]QIU Ting-sheng, WU Jin-gang, QIU Xiao-ping, et al.A discrete element method modeling for charging process in a bell-less top with two parallel hoppers[J].Computers and Applied Chemistry, 2015, 32(05):527-533 [20] MIO H, KADOWAKI M, MATSUZAKI S, et al.Development of particle flow simulator in charging process of blast furnace by discrete element method [J]. Minerals Engineering, 2012, 33: 27-33.