长期时效对ЭП866钢组织和力学性能的影响

张凯强,李激光,赵吉庆,唐广波

钢铁 ›› 2018, Vol. 53 ›› Issue (2) : 60-66.

PDF(2028 KB)
欢迎访问《钢铁》官方网站!今天是 2025年7月26日 星期六
PDF(2028 KB)
钢铁 ›› 2018, Vol. 53 ›› Issue (2) : 60-66. DOI: 10.13228/j.boyuan.issn0449-749x.20170354
钢铁材料

长期时效对ЭП866钢组织和力学性能的影响

  • 张凯强1,2,李激光1,赵吉庆2,唐广波2
作者信息 +

Effect of long term aging on microstructure and mechanical properties of ЭП866 steel

  • 张凯强1,2,李激光1,赵吉庆2,唐广波2
Author information +
文章历史 +

摘要

研究了ЭП866钢650 ℃下经最长2 000 h时效处理后组织和力学性能的变化规律,并运用Thermo-Calc热力学软件研究了钢中铬质量分数变化对σ相平衡析出的影响。结果表明,650 ℃长期时效后,钢中的析出相主要为M23C6、MX、Laves和σ相,同时发生了马氏体板条回复及析出相的粗化。材料的强度和硬度在500 h时效时间内下降较快,主要受析出相粗化和组织回复共同作用的影响;时效时间延长后,由于硬脆的σ相大量析出,强度和硬度缓慢下降。冲击吸收能量在1 000 h时效时间内呈下降趋势,主要受Laves相粗化和链状分布的M23C6的影响,时效时间延长后,组织回复引起软化的作用增强,冲击吸收能量又略有升高。Thermo-Calc计算结果表明,时效过程中σ相的析出与铬元素在晶界上的偏聚有关。

Abstract

Effect of aging at 650 ℃ for up to 2 000 h on microstructure and mechanical properties of ЭП866 steel was investigated,and Thermo-Calc software was used to study the effect of Cr content on the equilibrium precipitation behavior of σ phase. The results showed that after long-term aging at 650 ℃,precipitation phases in the steel consist of M23C6 、MX、Laves and σ phase. In addition,martensitic lath recovery and the coarsening behavior of precipitates also occurred. The sharp decrease of hardness and strength after aging for 500 h could be attributed to the combined effects of the coarsening of precipitates and the recovery of microstructure. However, these two properties decreased slowly with longer aging time,due to the large number of precipitation of σ phase,which was characterized as a hard and brittle phase. The impact energy decreased during aging for 1 000 h,resulting from the coarsened Laves phase and M23C6 particles distributed in chain-shape. Additionally,the softening effect by microstructure recovery brought about higher impact energy after longer aging time. Results from Thermo-Calc calculations show that the precipitation of the σ phase in this steel is related to segregation of Cr in the vicinity of grain boundaries during aging.

关键词

ЭП866 / 长期时效 / 组织 / 力学性能

图表

引用本文

导出引用
张凯强, 李激光. 长期时效对ЭП866钢组织和力学性能的影响[J]. 钢铁, 2018, 53(2): 60-66 https://doi.org/10.13228/j.boyuan.issn0449-749x.20170354
ZHANG Kai-Jiang, LI Ji-Guang. Effect of long term aging on microstructure and mechanical properties of ЭП866 steel[J]. Iron and Steel, 2018, 53(2): 60-66 https://doi.org/10.13228/j.boyuan.issn0449-749x.20170354
中图分类号: TG142.73   

参考文献

[1] 中国航空材料手册编辑委员会. 中国航空材料手册: 第1卷, 结构钢、不锈钢[M]. 北京:中国标准出版社, 2001.
[2] 孙铁峰, 李明许, 宋玺玉, 等. 锻造工艺对1Cr16Co5Ni2Mo1WNbVN钢组织和性能的影响[J]. 沈阳航空航天大学学报, 2012,29(3):38-42.
SUN Tie-feng, LI Ming-xu, SONG Xi-yu, et al. The influence of forging technology on the structure and property of 1Cr16Co5Ni2Mo1WVNb N steel[J]. Journal of Shenyang Aerospace University, 2012,29(3):38-42.
[3] 郭淑娟, 闫伟, 张秀丽. 化学成分对马氏体不锈钢эп866组织与性能的影响[J]. 科学技术与工程, 2010,(14):3471-3474.
GUO Shu-juan, YAN Wei, ZHANG Xiu-li. Influence on the Microstructure and Properties of the Chemical Composition of Martensitic Stainless Steel эп866[J]. Science Technology and Engineering, 2010,(14):3471-3474.
[4] 杨钢, 刘正东, 程世长, 等. 热处理工艺对耐热钢эп866冲击韧性的影响[J]. 钢铁研究学报, 2002,14(5):30-34.
YANG Gang, LIU Zheng-dong, CHENG Shi-chang, et al. Effect of Heat Treatment on Impact Toughness of Heat-Resistant Steel эп866[J]. Journal of Iron and Steel Research, 2002,14(5):30-34.
[5] 赵义瀚, 赵成志, 王健楠, 等. δ铁素体形成机制以及对马氏体耐热钢冲击功的影响[J]. 钢铁, 2013,48(4):70-75.
ZHAO Yi-han, ZHAO Cheng-zhi, WANG Jian-nan, et al. Forming Mechanism of δ-Ferrite and Its Effect on Martensite Heat-Resistant Steel Impact Energy[J]. Iron and Steel, 2013,48(4):70-75.
[6] Rojas D, Garcia J, Prat O, et al. Design and characterization of microstructure evolution during creep of 12% Cr heat resistant steels[J]. Materials Science and Engineering: A, 2010, 527(16): 3864-3876.
[7] 雍岐龙. 钢铁材料中的第二相[M]. 北京:冶金工业出版社, 2006.
[8] Li J, Zhang C, Liu Y. Influence of carbides on the high-temperature tempered martensite embrittlement of martensitic heat-resistant steels[J]. Materials Science and Engineering: A, 2016, 670: 256-263.
[9] 余涛, 刘新宝, 郝巧娥, 等. 高铬钢蠕变析出相变化分析概述[J]. 金属世界, 2016, (2): 26-30.
YU Tao, LIU Xin-bao, HAO Qiao-e, et al. Analysis overview of high-chromium steel creep precipitated phase change[J]. Metal World, 2016, (2): 26-30.
[10] Yamada K, Igarashi M, Muneki S, et al. Creep properties affected by morphology of MX in high-Cr ferritic steels[J]. ISIJ international, 2001, 41(Suppl): S116-S120.
[11] 王学, 于淑敏, 任遥遥, 等. P92钢时效的Laves相演化行为[J]. 金属学报, 2014, 50(10):1195-1202.
WANG Xue, YU Shu-min, REN Yao-yao, et al. Laves phase evolution in P92 steel during aging[J]. Acta Metallurgica Sinica, 2014, 50(10): 1195-1202.
[12] 刘鸿国,李生志,熊伟,等.马氏体耐热钢中Laves相的析出行为[J]. 材料热处理学报,2015,36(9):109-113.
LIU Hong-guo, LI Sheng-zhi, XIONG Wei, et al. Precipitation behavior and influence of Laves phase in martensitic heat resistant steel[J]. Transactions of Materials and Heat Treatment,2015,36(9):109-113.
[13] Yan P, Liu Z. Toughness evolution of 9Cr–3W–3Co martensitic heat resistant steel during long time aging[J]. Materials Science and Engineering: A, 2016, 650: 290-294.
[14] Andersson J O, Helander T, Hoglund L, et al. Thermo-Calc & Dictra, Computational Tools for Materials Science[J]. Calphad, 2002,(26):273- 312.
[15] 王国华.相的析出对双相不锈钢组织性能的影响[J].中国冶金, 2011, 21(6): 15-18.
WANG Guo-hua. Influence of the sigma phase precipitation on the microstructure and properties in duplex stainless steel[J]. China Metallurgy, 2011, 21(6): 15-18.

基金

钢铁流程关键要素的协同优化和集成应用;国家重点研发计划资助项目

PDF(2028 KB)

8

Accesses

0

Citation

Detail

段落导航
相关文章

/