17Cr2Ni2Mo齿轮用钢热变形动态再结晶行为

余新平,潘光永,齐永杰,黄庆华,潘巧玉

钢铁 ›› 2019, Vol. 54 ›› Issue (11) : 94-100.

PDF(1209 KB)
欢迎访问《钢铁》官方网站!今天是 2025年7月31日 星期四
PDF(1209 KB)
钢铁 ›› 2019, Vol. 54 ›› Issue (11) : 94-100. DOI: 10.13228/j.boyuan.issn0449749x.20190153
钢铁材料

17Cr2Ni2Mo齿轮用钢热变形动态再结晶行为

  • 余新平,潘光永,齐永杰,黄庆华,潘巧玉
作者信息 +

Dynamic recrystallization behavior of steel for 17Cr2Ni2Mo gears

  • 余新平,潘光永,齐永杰,黄庆华,潘巧玉
Author information +
文章历史 +

摘要

为了探索材料热塑性变形工艺理论,针对热轧态17Cr2Ni2Mo齿轮用钢进行热力模拟试验,研究材料在应变速率=0.01~10 s-1、热变形温度t=1 050~1 150 ℃条件下的动态再结晶行为。结果表明,在较高应变速率下,应力在峰值后,出现动态回复或持续性动态再结晶软化,在较低应变速率下,应力呈现波浪多峰值状,出现多次动态再结晶软化。通过加工硬化率随应变变化曲线(θε),确定了动态再结晶临界特征应变量εc,结合峰值应变量εp统计得到εc/εp比值为0.629~0.854,并可知当应变速率一定时,εc随着温度升高而减小,当温度一定时,εc随应变速率的增大而增大。同时建立了流变应力本构方程,数据验证平均相对误差为1.705%。最后建立了动态再结晶动力学模型。

Abstract

 The thermal simulation test was carried out on the steel of hot rolled 17Cr2Ni2Mo gears. The dynamic recrystallization behavior of the materials were studied at strain rate=0.01~10 s-1 and hot deformation temperature t=1 050~1 150 ℃,which can provide theoretical guidance for exploring thermoplastic deformation processes of materials. The results show that the flow stress appears as a dynamic recovery or a continuous dynamic recrystallization softening phenomenon after the peak value at a higher strain rate. The flow stress exhibits multiple peaks in the wave and multiple dynamic recrystallization softening occurs at lower strain rates. The dynamic recrystallization critical characteristic strain εc is determined by the work hardening rate with strain curve (θε),and the εc/εp ratio is statistically between 0.629 and 0.854. It can be seen that εc becomes smaller as the temperature increases as the strain rate is constant. When the temperature is constant,εc becomes larger as the strain rate becomes larger. At the same time,the constitutive equation of flow stress is established,and the average relative error of data verification is 1.705%. Finally,a dynamic recrystallization kinetics model was established,which can provide a theoretical reference for the formulation of related thermal processing processes.

关键词

17Cr2Ni2Mo钢 / 流变应力 / 动态再结晶 / 临界应变

Key words

17Cr2Ni2Mo steel / flow stress / dynamic recrystallization / critical strain

图表

引用本文

导出引用
余新平, 潘光永, 齐永杰, . 17Cr2Ni2Mo齿轮用钢热变形动态再结晶行为[J]. 钢铁, 2019, 54(11): 94-100 https://doi.org/10.13228/j.boyuan.issn0449749x.20190153
YU Xinping, PAN Guangyong, QI Yongjie, et al. Dynamic recrystallization behavior of steel for 17Cr2Ni2Mo gears[J]. Iron and Steel, 2019, 54(11): 94-100 https://doi.org/10.13228/j.boyuan.issn0449749x.20190153

参考文献

[1]童惠荣,周立中,宾远红.17Cr2Ni2Mo钢十字轴失效分析[A].2013年全国失效分析学术会议论文集[C],2013.
[2]李光瑾,陈德华,任颂赞,等.重载大模数齿轮深层渗碳工艺精益化探讨[J].热处理技术与装备,2013,34(1):31-35.
LI Guang-jin,CHEN De-hua,REN Song-zan,et al.Discuss of Deep Carburizing Lean Process for Heavy-Duty Large Module Gear[J].Heat Treatment Technology and Equipment,2013,34(1):31-35.
[3]赵忠.金属材料及热处理:第三版[M].北京:机械工业出版社,2006.
[4]李其,杨运民,陶凤云等.17Cr2Ni2Mo齿轮轴淬火过程的数值模拟研究[J].大型铸锻件,2017,(4):9-14.
LI Qi,YANG Yun-ming,TAO Feng-yun,et al.Research on Numerical Simulation of Quenching Process for 17Cr2Ni2Mo Gear Shaft[J].Heavy Casting and Forging,2017,(4):9-14.
[5]董汉伟,王大宇,宋利锋,等.淬火温度对渗碳17Cr2Ni2Mo钢组织与性能的影响[J].金属热处理,2015,40(5):144-146.
DONG Han-wei,WANG Da-yu,SONG Li-feng,et al.Effects of quenching temperature on microstructure and properties of carburized 17Cr2Ni2Mo steel[J].Heat Treatment of Metals,2015,40(5):144-146.
[6]田嘉,裴檑,郭贵堂.17Cr2Ni2Mo齿轮渗碳后空冷产生裂纹原因及解决办法[J].黑龙江科技信息,2013,(3):80.
TIAN Jia,PEI Lei,GUO Gui-tang.Causes and solutions of air cooling cracks in 17Cr2Ni2Mo gear after carburizing[J].Hei long jiang Science and Technology Information,2013,(3):80.
[7]张伟.17Cr2Ni2Mo钢制采煤机行走轮的工艺研究[J].煤矿机电,2010,(4):80-81.
ZHANG Wei.Technologic Research of Shearer’s Tractive Wheel of 17Cr2Ni2Mo Steel[J].Colliery Mechanical & Electrical Technology,2010,(4):80-81.
[8]杨静,徐光,韩斌,等.Q345B钢动态再结晶动力学模型研究[J].武汉科技大学学报,2012,35(2):85-88.
YANG Jing,XU Guang,HANG Bin,et al.Study of dynamic recrystallization of Q345B steel[J].Journal of Wuhan Univerity of Science and Technology,2012,35(2):85-88.
[9]李冬勤,徐磊,黄兴民,等.7A04铝合金动态再结晶的临界应变研究[J].材料工程,2013,(4):23-27.
LI Dong-qin,XU Lei,HUANG Xing-min,et al.Investigation on Critical Strain of Dynamic Recrystallization for 7A04 Aluminum Alloy[J].Journal of Materials Engineering,2013,(4):23-27.
[10]Dan ZHANG,Ya zheng LIU,Le-yu ZHOU,et al.Dynamic recrystallization behavior of GCr15SiMn bearing steel during hot deformation[J].Journal of Iron and Steel Research, International,2014,21(11):1042-1048.
[11]权国政,石彧,赵周磊,等.42CrMo钢热塑性变形诱导动态再结晶行为的动力学描述[J].材料热处理学报,2012,33(10):155-162
QUAN Guo-zheng,SHI Yu,ZHAO Le,et al.Dynamic recrystallization behavior of 42CrMo steel induced by thermal deformation[J].Transactions of Materials and Heat Treatment,2012,33(10):155-162
[12]Kim S I, Yoo Y C.Dynamic recrysallization behavior of AISI304 stainless steel[J].Materials Science and Engineering A.2010,311 (1-2):108-113.
[13]王鑫,董洪波,邹忠波,等.AerMet100钢的热变形显微组织演变及动态再结晶行为[J].特种铸造及有色合金,2016,36(1):121-125.
WANG Xin,DONG Hong-bo,ZOU Zhong-bo,et al.Microstructure evolution and dynamic recrystallization behavior of hot deformed AerMet100 steel[J].Special Casting & Nonferrous Alloys,2016,36(1):121-125.
[14]Hodgson P D,Gibbs R K.A mathematical model to predict the mechanical properties of hot rolled C-Mn and microalloyed steels[J].ISIJ International,1992,32(12):1329-1338.
[15]Manohar P A,Kyuhwan LIM,Rollett A D,et al.Computational exploration of microstructural evolution in a medium C-Mn steel and applications to rod mill[J]. ISIJ International,2003,43(9):142-1430.

基金

浙江省教育厅科研项目资助

PDF(1209 KB)

10

Accesses

0

Citation

Detail

段落导航
相关文章

/