投审稿入口

高炉高钛渣系冶炼条件下的脱硫能力研究

Study on the desulfurization capacity of blast furnace producing the byproduct of high-titanium slag

  • 摘要: 以某2000 m3高炉为对象,收集243炉次渣铁成分数据,分析高钛渣系冶炼脱硫的关键影响因素,并用SEMEDS研究渣铁中锰、钛、硅的存在形态。认为在高钛渣系冶炼条件下:(1)S的关键影响因子为Mn、LS、Ti、Si,LS的关键影响因子为Mn、Ti、Si,并在此基础上提出预估铁水S含量的经验公式;(2)为提高脱硫能力,最好能控制Mn≥0.12%,Ti≥0.25%,Si≥0.12%,切不可追求在低Ti的同时实现低S;(3)可考虑适当配加一些锰含量较高的矿石,以提高脱硫能力;(4)由于(TiO2)严重弱化(CaO)的脱硫作用,可考虑适当添加一些含硼矿物,与(TiO2)形成低熔点物质,以减弱其影响。

     

    Abstract: Focusing on a 2000m3 blast furnace,the data regarding the compositions of 243 heats of iron and slag is collected to analyze the key factors that influence the desulfurization capacity of the furnace producing the byproduct of high-titanium slag,and SEM-EDS technology is used to study the existence form of Mn,Ti,and Si in the iron and slag.It is believed that for the said furnace:(1) the key factors influencing S are Mn,LS,Ti,and Si,while influencing LS areMn,Ti,and Si.Based on this conclusion,an empirical formula for predicting the S content in hot metal is proposed;(2) it is recommended to control Mn to be≥0.12%,Ti≥0.25%,and Si≥0.12% to improve desulfurization capacity,instead of attempting both low S and low Ti simultaneously;(3) it is also advised to charge some ores with higher Mn content desulfurization capacity improvement;(4) some boron-containing ores can be added to form low-melting-point substances with(TiO2) to compensate the severely weakened desulfurizing effect of(CaO) caused by(TiO2).

     

/

返回文章
返回