冷连轧过程中间厚度在线优化设定技术

刘相华;徐俊;邱格君

钢铁 ›› 2007, Vol. 42 ›› Issue (8) : 49-0.

欢迎访问《钢铁》官方网站!今天是 2025年8月11日 星期一
钢铁 ›› 2007, Vol. 42 ›› Issue (8) : 49-0.
压力加工

冷连轧过程中间厚度在线优化设定技术

  • 刘相华1,徐俊1,2,邱格君2
作者信息 +

On Line Optimization of Intermediate Thickness SetUp on Tandem Cold Mill

  • 刘相华1,徐俊1,2,邱格君2
Author information +
文章历史 +

摘要

为了提高冷连轧过程中轧制稳定性与模型计算精度,以宝钢1220五机架冷连轧机为研究对象,充分考虑到冷连轧过程的生产工艺特点,直接采用原始非线性负荷模型,在不做任何有损计算精度的数学简化的前提下,利用powell优化方法实现冷连轧过程中间厚度在线优化设定,不但提高了计算速度与计算精度,而且解决了计算过程中不收敛的问题,杜绝现场因模型问题而造成意外停机事故的发生,具有进一步推广应用的价值。

Abstract

In order to improve the stabilization and calculation precision for cold rolling,the 1220mm fivestand cold tandem mill was taken as an object of investigation. With consideration of characteristics of cold rolling, the original nonlinear load model is adopted with Powell optimization to realize online optimization of intermediate thickness steup without reduction of calculation precision.In this way not only the calculation speed and precision can be improved largely, but also nonconvergence in the calculation procedure can be prevented. Because of avoidance of troubles caused by problems in calculation model, more benefits can be obtained.

关键词

冷连轧 / 非线性 / 中间厚度 / powell优化

Key words

cold tandem mill / nonlinearity / intermediate thickness / Powell optimization method

图表

引用本文

导出引用
刘相华, 徐俊, 邱格君. 冷连轧过程中间厚度在线优化设定技术[J]. 钢铁, 2007, 42(8): 49-0
LIU Xianghua, XU Jun, QIU Gejun. On Line Optimization of Intermediate Thickness SetUp on Tandem Cold Mill[J]. Iron and Steel, 2007, 42(8): 49-0

8

Accesses

0

Citation

Detail

段落导航
相关文章

/